T&C TC36.NG05.C Installation Instructions Manual - Ember Material
Note:
Ember material placement
and amount will affect
flame appearance.
More ember material
results in lower flame
height.
Add or remove as needed
until desired flame affect.
Reduce the amount used
on Propane models, as too
much will create soot
4
TC36.NG05.C 290409-12
Fig. #5
Ember Material
Fig. #6
Alargebagofembermaterialisshippedwiththefireplaceandneedstobeinstalledon
theburnertoensureoptimumperformanceandflameappearance.Abagofcoalchunks
and lava rock is also supplied this must only be used
around the burner pan to cover up
the gas lines and brackets.
1. Pullapartthematerialintoembersizepieces(approximately1”squares)and
gentlyplacethemintotheburnerpan.Donotcompress,leavethemlooseforbest
performance.
2. Filltheburnerpanwithembersuntillevelwiththetopofthepanatrear,andgradually
slopeforwardtothefireboxflooratthefront,coveringbothburnertubes.
3. Placeremainingembermaterial,coalchunksandlavarockoutsideoftheburnerpan
as desired to cover-up gas lines and brackets.
Do not put coal chunks or lava rock
inside burner pan as this will cause sooting and the burner to malfunction.
Embersonlyinthisarea.
Embers,coalchunksandlavarock.