T&C TC42.NG05.C Installation Instructions Manual - Ember Material
4
TC42.NG05.C 160508-12
Fig. # 6
Ember Material
Fig. # 6a
A large bag of ember material is shipped with the fi replace and needs to be installed on
the burner to ensure optimum performance and fl ame appearance. A bag of coal chunks
and lava rock is also supplied this must only be used around the burner pan to cover up
the gas lines and brackets.
1.
Pull apart the material into ember size pieces (approximately 1” squares) and
gently place them into the burner pan. Do not compress, leave them loose for best
performance.
2.
Fill the burner pan with embers until level with the top of the pan at rear, and gradually
slope forward to the fi rebox fl oor at the front, covering both burner tubes.
3.
Place remaining ember material, coal chunks and lava rock outside of the burner pan
as desired to cover-up gas lines and brackets. Do not put coal chunks or lava rock
inside burner pan as this will cause sooting and the burner to malfunction.
Note:
Ember material placement and amount will affect fl ame appearance. More
ember material results in lower fl ame height. Add or remove as needed until
desired
fl ame affect.
Reduce the amount used on Propane models, as too much will create soot.
Embers only in this area.
Embers only in this area.
Embers, coal chunks and lava rock.
Embers, coal chunks and lava rock.