T&D RTR-601-130 User Manual - page 2
Operations Table
Compatible Base Units / Repeaters
Battery Charger for RTR-601
(with USB communication)
Network Base Station
RTR-500NW (Wired LAN Type)
RTR-500AW (Wireless LAN Type)
Wireless Base Station / Repeater
RTR-500
Battery Charge Dock
RTR-6BD
Menu Contents
[Check Data] > [Data List] > [Check Data]
By selecting the [Check Data] menu, all recorded
data in the Remote Unit is displayed in a list in
descending order (from newest to oldest data).
Select data by moving the cursor and press the
The left screen shows the 83rd data reading highlighted by the
cursor.
Details of the selected data (date and time of
recorded data, measured-item, user name, and
judgement result) will be displayed.
Judgement OK
Lower Limit Error
Upper Limit Error
[Select User] / [Select Item]
Select from the list of Users and Items setup in the
supplied software.
If you have registered Work Groups, it is also pos-
sible to select from the [Select Work] menu.
[Judgement LED]
By setting to "LED ON", the Judgement LED will
blink when a measurement exceeds the set upper
or lower limit*.
* Upper and lower limits can be set using the
supplied software.
[Button Sound]
Turn ON or OFF the beep which sounds when a
button is pressed.
[Backlight]
The "ON in Use" option will backlight the display
for three seconds only during operation.
[Contrast]
Use to adjust the contrast of the display.
[Unit of Temp]
Select Celsius [°C] or Fahrenheit [°F].
[Remote Info]
The Group ID* and Remote Unit Name can be
viewed here for the unit being used.
* The Group ID is automatically assigned upon
registering a Remote Unit.
Message Display
Settings Change Message
If any settings changes have been made via wireless communica-
tion to the unit in use, a notification message will be displayed for
about two seconds. After that, you will be automatically returned to
the top screen.
This message will be displayed regardless of
what settings have been made in the unit.
Even when the power is off, the unit will auto-
matically turn on to display the message.
Sensor Error Message
Please contact your local distributor if you
see this message.
How to Read the LCD Display
Top Screen
By turning the power to ON, the Top Screen, such as below, will appear.
1
2
3
4
5
6
1
Current Date/Time and User Name
2
Current Temperature (°F/°C)
3
Work Group Name
A maximum of 12 characters can be displayed as a work group name.
4
Measured Item and Count No.
The item being measured and a count number to show how many times this
item has been measured are shown here. A maximum of 8 characters can be
displayed for a measured item. The count number will be reset to zero every
time a Work Group Table is sent via software.
The above screen shows the temperature of a cutlet that has been measured
two times.
5
Icons (Battery Level / Communication Antenna / Button Lock)
This icon shows the remaining amount of battery power. When
the battery is too low to measure temperature, the "Please
charge batteries" message will appear.
This icon appears during wireless communication with the Base Unit.
This icon appears when "Button Lock" is set to ON in the software.
Button operation will be OFF for all buttons except for the
and Power buttons.
6
Recording Mode (Endless)
Main Menu Screen
By pressing the