T-Eye ADR-3000 User Manual - Main Features
2
Main Features
Unlike other in-car recording systems, the T-eye Drive Recorder is used to record both video
and audio data in a continuous loop fashion. If the vehicle is involved in an accident such as a
collision, impact, and sudden acceleration-related incident, this data is marked and stored. One
may thereafter analyze the data to find its root cause by playing back the scenes of interest and
where acceleration, vehicle speed, direction, and location are available for review. Added to the
recording is vehicle speed and direction and GPS location.
Continuous recording
The video and audio data from the front and interior views is continuously recorded while
power on. When the capacity of the SD Card has been reached, the older files are overwritten
by the latest ones in a “round-robin”, first in, first out fashion.
Pre and post event recording
When impact or unusual acceleration or deceleration is detected by the built-in G-Sensor and
has exceeded the preset limit or one activates the manual emergency record button, the
recorded video data is locked-in and is erased only by an authorized party and by using a PC or
laptop, accessing the SD card. Event data records 1 minute before and 1 minute after(Note: The
User may set the pre-event time to either 1 minute, 2 minutes or 3 minutes of pre-event
recording). The next time the SD card is read by the unit, the unit’s set up parameters will be
uploaded into the recorder. As previously mentioned, stored event recording data in the SD
card will not be erased by the unit, and where this must be done manually by the User.
Night view recording with Infra-Red Light
The included IR (Infra-Red) Light module with adjustment used this invisible light source to assist
in recording nighttime views from the interior facing camera.
Playback of video/audio data
The recorded data can be played back using the provided playback software which resides on
the SD card. By removing the SD card and accessing the Player folder and double clicking on the
“Player.exe” line starts the playback software.
Data analysis
The recorded data can be easily analyzed for speed, vehicle location and direction of travel
including impact by using the T-eye Player that is found on conveniently on the supplied SD card.