Compressor plasma cutting equipment operating manual plasma cutting gb inglese gb site cut 10
Operating manual plasma cutting gb inglese gb index warning 1. Conformity declaration pag. 2 1.1. Raee norm pag. 2 2. Safety precautions pag. 2 3. General description pag. 3 3.1. Description of devices on the machine pag. 3 site cut 10 power source pag. 4 3.2. Safety devices pag. 4 3.3. Explanation ...
Operating manual plasma cutting gb inglese gb electricshock–maybefatal. Install and earth the welding machine according to the applicable regulations. Do not touch live electrical parts or eletrodes with bare skin, gloves or wet clothing. Isolate yourselves from both the earth and the workpiece. Mak...
Operating manual plasma cutting gb inglese gb picture 3 : site cut 10 front and rear view figure 3 3.1 3.1 description of devices on the machine site cut 10 power source 3.2 safety devices this system comes equipped with the following safety devices: (see table 1 ) overload cutout:to avoid overload ...
Operating manual plasma cutting gb inglese gb table1:safetydevicesignal. Signal function on/off on/off reset function, blink for 5 sec. Torch tiigger cutting pilot arc on fast blinking for 10 sec. - fast blinking thermal failure on torch maintenance fast blinking fast blinking do not remove or short...
Operating manual plasma cutting gb inglese gb 4.2 cutting start-up read the standards cei 26/9 – cenelec hd 407 and cei 26.11 – cenelec hd 433 carefully before using the equipment, and make sure the cable insulation is fully intact. Make sure the trigger has not been pressed. Turn the machine on usi...
Operating manual plasma cutting gb inglese gb hold the torch upright while cutting. When you have finished cutting and released the trigger, air will continue to leave the torch for approximately 20-25 seconds to allow the torch to cool down. The standard tip have hole 0,8 mm. , suggested from 18 to...
Operating manual plasma cutting gb inglese gb 5. Replacing consumer parts always shut off the machine before replacing consumer parts. The electrode must be replaced when it has a crater in the center approximately 1 mm deep. The diffuser must be replaced when some areas are blackened. Due to its sm...
Operating manual plasma cutting gb inglese gb 1 7. Maintenance always cut off the power supply to the machine before any operation, which must always carried out by qualified personnel. 7.1 generator maintenance in the case of maintenance inside the machine, make sure that the switch b is in positio...
Operating manual plasma cutting gb inglese gb 8.2 plasma torch t3981120 hand torch 4 m. - compressor 1 r4919102 torch head 1a r4929101 o-ring 2 r4924109 electrode hf - back arc stricking 3 r4622101 air diffuser 4 r4913130 tip 0,65 ( 10-20 a ) back arc stricking r4913131 tip 0,8 ( 20-30a ) back arc s...
Operating manual plasma cutting gb inglese gb page 10
Partita iva 03377580240 telefono +39 0444 552887 telefax +39 0444 284875 ter s.R.L via madonna delle grazie 27 costabissara 36030 vicenza internet: http//www.Terwelding.Com e-mail: info@terwelding.Com.
