T&R Site Cut 10 Operating manual - page 9
OPERATING MANUAL
PLASMA CUTTING
GB
Inglese
GB
1
7. Maintenance
Always cut off the power supply to the machine before any operation, which must
always carried out by qualified personnel.
7.1 Generator maintenance
In the case of maintenance inside the machine, make sure that the switch B is in
position “O” and that the power cord is disconnected from the mains.
Site Cut 10 power source
Periodically open the cover panel and clean the interior of the machine from the
accumulated metal dust, using low pressure compressed air.
The air compressor is equipped with an air filter ( Pos. 1 – Picture 10 ); periodical-
ly, remove this filter and clean it with low flow air compressed.
7.2 Precautions after repairs
After making repairs, take care to organize the wiring so that there is secure insu-
lation. Do not allow the wires to come into contact with moving parts or those that
heat up during operation. Reassemble all clamps as they were on the original ma-
chine, to prevent a connection from a wire accidentally break or be disconnected.
To ensure earth connection, also mount the screws with geared washers as on the
original machine.
8. Spare parts
8.1 Site Cut 10 power source
Figura 10: Viste generali Site Cut 10
Ref.
Description
5
Main power switch 230 VAC
7
Plasma torch 4 mt (see torch spare parts)
4
Regulation current knob
Potentiometer 1 Kohm
1
Green Led 3 mm
3
Red Led 3 mm
2
Yellow Led 3 mm
Led holder
6
Earth clamp
PAGE 8