T Scale TFB sereis Service Manual - 5. Operation
TPF / TFB Series Floor Scale Service Manual
- 8 -
5. OPERATION
5.1 Operation
Interface connection (power issupplied via the connecting cable of the
display unit)
Initial Commissioning
Connection of peripheral devices
Adjustment, linearization and verification (Only it can be verifiable,
when it’s connected with suitable display unit)
And the correct operation will be in the operation instructions included of
the display unit.
Continuous optimal performance is guaranteed;
For Weighing operation, all objects must be placed centrically of the floor
scale and may not hang over the edges or the ramps
Check adjustment at regular intervals
Avoid falling load, shock loads and impacts from the
side.
5.2 Operation Limits
The floor scales are designed extremely robust. The load limits according
to the following table should not be exceeded..
Depending on the type of load receptacle, the static carrying capacity. The
maximum admissible load is
Weighing Range
1000kg 2000kg 3000kg
Centre
3000kg
4500kg
4500kg
Side stress
2000kg
3000kg
3000kg
One side
1000kg
2000kg
2000kg
5.3 Load / Unload weighing
Place the load on the scales using a crane or forklift or using proper lifting
technics. Ensure the load is not swinging when it is placed onto the scales.
Lift the load first vertically at least 10cm above the scales before it is
removed or newly placed