TA Indoor Wave User Manual - page 12
12
Setting the armrests.
Armrest height in distance to the seat and
armrest cushion distance to the back can be adjusted.
Armrest cushion position relative to the back
is adjusted by loosening four screws (A)
under the armrest with a slotted screwdriver.
Once the screws are loosened, armrest cushion can be
pushed forward / backward and positioned to the
user.
Armrest height is adjustable by loosening screws (B)
on the armrest stanchion.
Setting up the legsupport.
The legsupport is mounted on the chairs seat frame.
Legsupport position relative to the seat is adjusted by
loosening the two hex screws (A) (6 mm) on the
inside of the seat frame. The legsupports can be
adjusted to fit the user's femur length.
Legsupport length or the distance between the seating
surface and base plate is adjusted by loosening the
hex screw (B) (6 mm) on the back of the legsupports
down tube. When the footrest is in the desired
distance from the seat tighten hex screw again.
Footplate angle to the floor is adjusted by loosening
the hex screw (C) (6 mm) on the side of the footplate.
When the footplate is in the desired angle tighten the
screw - HARD.
Legsupport angle is adjusted by loosening the
thumbscrew by hand, set the legsupports in the
desired position and tighten the screw.
Installation of the lap belt.
There can be fitted lap belt on the TA Indoor Wave.
TA Services A/S recommends that the lap belt is
fastened either by the back mount (C) or on a bracket
in the chair seats C profile.
A
B
C
A
C
B
D