TA Service iQ FWD: 97070 User Manual - page 12
12
This brake method results in a very abrupt deceleration and should only be performed in an emergency and
only if the user of the power chair is prepared.
WARNING!!
Slowing down by pressing the On /Off button creates the risk that the user's torso could fall over.
This could lead to, the user falling out of the power chair.
Slowing down in this manner should be avoided on sloping surfaces and ramps.
Force of obstacles.
TA iQ can climb obstacles, making it able to run over doorsteps and the like.
At very steep increases may inlet and a certain speed be necessary.
In the interest of the power chair's stability by forcing different levels it is important that the seat is elevated
as little as possible and is as close to an upright position as possible to minimize this risk.
Never exceed the max of height kerb as described under TECHINCHAL DATA SHEET
WARNING!!
By forcing level differences, it is important that the power chair runs perpendicular to the obstacle in
order to minimize the risk that the power chair should tilt.
WARNING!!
By forcing level differences with the seat tilted or hoisted there is a risk that the power chair can tip
over. By forcing level differences, it is highly important that the seat is elevated as little as possible and
is as close to an upright position as possible to minimize this risk.
Driving on slopes.
Driving on sloping surfaces should be carried out forwards and at a slow pace.
Never exceed the max safe slope as described under TECHNICAL DATA SHEET
WARNING!!
Driving on slopes should be avoided because a slope to the side can cause the power chair to tip over.
When driving on slopes, the seat should not be lifted to keep the power chair stable.
Surfaces
TA iQ is fitted with a pattern tread on the big drive wheel for best grip. If the tread is worn it will affect the
grip on the surface.
When driving on uneven surfaces, pay extra attention (like on sand, ice/show, grass etc.) it can have an affect
on the stability and the steering.
If a tyre without a tread pattern is used, it will have the same effect as if the tread is worn.
Driving in darkness
TA iQ can be acquired with lights as an option. Drive only in darkness when light in the front and back are
applied or as per the applicable national regulations.
AFTER DRIVING.
Always leave the chair off and put on lowest speed.
NB! Leaving the chair turned on will draw power from batteries, with reduced remaining driving
distance to follow.