Tab Wheels Gen 2 User Manual - page 21
21
NOTE- Only the indicator light on the charger will tell you the status of the
battery during charging.
10. Safety Alerts
During operation, if there is a system error or illegal operation performed
with your TAB | WHEELS GEN 2, the system cannot enter self-balancing
mode, so the device will prompt the user in a variety of ways. You will
notice the Running Indicator Light will turn RED and you will hear a beep
sound alerting you to take precaution and cease operation. The following
are common occurrences where you will hear the Safety Alerts; these
notices should not be ignored, but appropriate action be taken to correct
any illegal operation, failure or errors.
Ø
Prohibited riding surfaces (uneven, too steep, unsafe, etc.)
Ø
When you step on the TAB | WHEELS GEN 2, if the platform is
tilted more than 10 degrees forward or backward.
Ø
Battery voltage is too low.
Ø
The device is still charging.
Ø
During operation, the platform self-initiates to tilt due to excess
speed.
Ø
Overheating, motor temperature is too high.
Ø
The device has been rocking back and forth over 30 seconds.
Ø
System enters protection mode, the alarm indicator will light up
and buzzer will alarm (this typically occurs when the battery is
about to die).
Ø
If the platform is tilted forward or backward more than 35
degrees, TAB | WHEELS GEN 2 will power off.
Ø
If the tire is blocked, TAB | WHEELS GEN 2 will stop after 2
seconds.
Ø
When the battery level has depleted below protection mode, the
TAB | WHEELS GEN 2 engine will power off after 15 seconds.
Ø
While sustaining a high discharge current during operation (such
as driving up a steep slope for a long period of time), the TAB |
WHEELS GEN 2 engine will power off after 15 seconds.