Tab Wheels Gen 2 User Manual - page 6
6
A. Operating Principles
A.1 How TAB | WHEELS GEN 2 Works
The TAB | WHEELS GEN 2 uses digital electronic gyroscopes and
acceleration sensors to control balance and motion intelligently,
depending on the user’s center of gravity. The device also uses an
intelligent control system to drive the brushless motors that are located
within the Wheels. The TAB | WHEELS GEN 2 has a built-in inertia
dynamic stabilization system that can help assist with balance when
moving forward and backwards, but not while turning.
TIP -To increase your stability, you must shift your weight in order to
overcome the centrifugal force during turns, especially when entering a
turn at higher speeds.
A.2 PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
Step 1: Getting Started - Take your TAB | WHEELS GEN 2 out of the
box and place it flat on the floor. Press and hold the power button, located
on the front of your TAB | WHEELS GEN 2 until you hear beep sound.
There are two sensor switches under the pedals of TAB | WHEELS GEN
2, when the user steps on them, the sensors are activated, TAB |
WHEELS GEN 2 will automatically adjust to the equilibrium state; when
rider get off from TAB | WHEELS GEN 2, sensors are deactivating, and
TAB | WHEELS GEN 2 enter into standby mode.
Step 2: Checking the Display Board - located in the center of your
TAB | WHEELS GEN 2. The Battery indicator lights should be lit,
indicating there is power to the device.