TabletKiosk Sahara Slate PC i500 Quick Start Manual - page 6
NOTE: If you find the “Standard Calibration” to be too imprecise, the “Advanced Calibration” mode offers 9,
16 or 25 points for calibrating. We suggest starting at 9 points. For both modes, it is highly recommended
that you use the stylus, rather than your finger, to produce to most accurate results.
3.
Follow the on-screen instructions by
pressing and holding on each red
square that appears until you are
told to lift to proceed. To quit this
routine without saving the data, hit
on your keyboard if you have
one connected, or simply wait a
few moments without touching the
screen and the test will time out.
4.
When the calibration is complete, you
can test the screen accuracy by either
tapping around the screen, or using the “Draw” test in the “Tools” tab in the main window
of the PenMount Control Panel.
Connecting to a Wireless Network
1.
Turn on the WiFi transmitter using the toggle
switch on the top of your tablet.
2.
In the Windows 7 System Tray, tap on the “Wire-
less Networks” icon.
3.
From the list that appears, tap to select the
network to which you wish to connect and
then tap the “Connect” button. If no wireless
networks appear after a few moments, tap on
the refresh button located on the right side of
the dialog box.
4.
If the wireless network you are attempting to
connect to is security-enabled, you will see a dia-
log box requesting a network key or password.
The key/password (your network administrator
should be able to supply this to you) must be en-
tered correctly or you will not be able to success-
fully connect to the network.
If you entered the network key correctly, you should now be connected to the wireless network.
If it appears you are connected to the network, but have limited or no actual connectivity, it is
most likely due to an improperly entered network key. Disconnect from the network by tapping
the “Disconnect” button and try to connect again. If you continue to have trouble connecting,
contact your network administrator for assistance.
Connecting with a Wireless Bluetooth Device
1.
Turn on the Bluetooth transmitter using the
toggle switch on the top of your tablet.
2.
If the Bluetooth Assistant is running, after
a few moments the "Add New Connection
Wizard" should start automatically (so skip to
step 3), otherwise go to "START > All Programs
> Bluetooth" and tap on the "Add New
Connection" button.
Touch each of the red squares that appear on-screen to
calibrate the touch screen. Remember to hold your finger or
stylus down on the square until it tells you to release.
Tap on the wireless networking icon in the
System Tray located on the task bar next to
the clock.