Taco D’MAND Installation And Wiring Instructions

Page of 2

Download

Bookmark us

INSTRUCTIONS

1. Unplug the D’Mand System power cord.

2. Connect Black, Green and Red leads from Motion Sensor to corre-

sponding Black, Green and White leads from Black 3-wire cord on

D’Mand System Pump (see wiring diagram). Use wire nuts provided

in kit. Use wire nuts or electrical tape to isolate Red and Black wire

leads in Gray Cord if round starter button is not installed.

D’MAND

SYSTEM

Motion Sensor

Installation and Wiring Instructions

102-205

PUMP

POWER

CORD

GRAY

2-WIRE

CORD

RED

BLACK

BLACK 3-WIRE

CORD

BLACK

GREEN

WHITE

GREEN

RED

MOTION SENSOR

ROUND

STARTER

BUTTON

Plant ID No. 001-3886 Supersedes: December 1, 2008

Effective: January 1, 2011

A Taco resource – saving product

1 2 Next › »

Page 1
Instructions 1. Unplug the d’mand system power cord. 2. Connect black, green and red leads from motion sensor to corre- sponding black, green and white leads from black 3-wire cord on d’mand system pump (see wiring diagram). Use wire nuts provided in kit. Use wire nuts or electrical tape to isolate ...
Page 2: D'Mand System Control Board
3. Remove electrical box cover and carefully remove electronics con- trol board from terminal strip. 4. Turn control board over and locate voltage dip switches in top left corner of board. (see diagram below.) 5. Slide dip switch connector from pin marked “5v” to pin marked “12v”. (see diagram below...