TAG HDIT 2U Reference Manual - page 2
TAG
®
Contact Information:
Mailing Address:
Technology Advancement Group
®
, Inc.
22355 TAG WAY
Dulles, VA 20166-9310
USA
Telephone Numbers:
Headquarters
+1 (703) 406-3000
Toll-Free 1 (800) TAG-POWER
(CONUS Only)
0800 - 1700
Eastern Time (USA)
Tech Support
+1 (703) 406-4516
Toll-Free 1 (877) TAG-TECH
(CONUS Only)
24 Hours-A-Day, 365 Days-A-Year
Internet:
Web Site
tag.com
tag.tech@tag.com
8
When servicing the HDIT 2U 1GHZ PIII SERVER, disconnect the unit from the
power source, and remove the power cord
(See Page 6)
. All 22
(See Figure 9)
screws
need to be removed from the Top Access Panel to service the unit.
Note: The two screws are located on the Front Panel of the
HDIT 2U 1GHZ PIII SERVER. Failure to remove those will result in damag-
ing the Top
Access Panel.
The HDIT 2U 1GHZ PIII SERVER should never be serviced without contacting TAG’s
Tactical Technical Support Team first.
Top Access Removal Instructions
NT 4.0 Server Load Instructions
Steps for loading Windows NT Server 4.0 on TAG 2U RAID Servers
1) Boot the computer with a bootable floppy (ie Windows 95 startup disk).
(disk must contain Command.Com and Fdisk).
2) Execute Fdisk and create a 4GB partition on the Hard Drive.
3) Remove the bootable floppy and put the NT 4.0 Server CD in the Drive.
4) Change the boot priority (in CMOS) so that the CD-ROM is now the primary
boot device.
5) When NT 4.0 Server begins to load press the
6) Type and load the MegaRAID drivers for the RAID card.
7) After drivers have loaded hit
8) On the 1
st
Setup screen hit
9) Type and load the Adaptec 7800 Ver3.02 drivers for NT. When prompted
select the U2 drivers for NT4.
10) Allow NT 4.0 Server to continue the load.
11) Delete the 4GB partition you created (with Fdisk).
12) Install NT 4.0 Server into the 4GB of unpartitioned space now recognized
by NT 4.0 Server.
13) Choose NTFS as your file system.
14) Follow all screen prompts until NT 4.0 Server asks to be rebooted.
15) When NT 4.0 Server resumes Setup (now in GUI) follow all screen prompts.
16) Install network drivers for the onboard network card (from diskette).
17) Finish NT 4.0 Server load.
Figure 9