Summary of HL 680
Page 1
Hl 680 radio data / voice user manual version 01/2009.
Page 2
1. Introduction the radio set hl 680 is dedicated to transmit timing data from chronoprinter 540, and also for voice communication between hl680s. The vocal communication has priority over the data transmission. Data awaiting transmission will be stored in memory and transmitted when the channel is ...
Page 3
• flexible antenna connector for a flexible antenna. • kit for bnc antenna is available (especially for the professional antenna) warning nevel carry the radio by the antenna.. Transmitting wihtout the antenna could damage the radio module. • battery pack to fix the battery pack, place the battery a...
Page 4
5. User setting the mode « user setting » is available when you switch on the radio. This allows you to change settings or customize the operator mode. ¾ activate the user setting: o to active the « user setting », switch on the radio (turn the button [ vol ] , and press simultaneously the keys ▼ an...
Page 5
6. Battery charge for a long live and an optimum use, you need to charge completely the battery pack before the first use. • recommended charging temperature. +10°c to +40°c • range of temperature (batt li-ion) -20°c to +60°c • only use the charger icom (bc-119) or other model proposed by icom or ta...
Page 6
7. Battery box (option ref : hl 680-8 ) to use the battery box (option) for the radio, insert 5 alkaline aa batteries (lr6) as shown on fig n°1. The battery box hl680-8 is water proof and conforms to the norm js, level 4. 1. Release the lock and open the cover as shown on the arrow 2 (fig 1) 2. Inse...
Page 7
Fig 1 fig 2 8. Connection connect the special data cable to the connector [sp mic] of the radio, and tighten the screw fastening. Important replace the cap of connector [sp mic] of the radio when the data cable is not connected. There is no risk of water infiltration in the radio even in the absence...
Page 8
9. Accessories • battery box – hl 680-8 • antenna – connector • nylon case – hl 680-9 10. Startup with chronoprinter 540 • ensure you have all the necessary cables: • configure the cp 540 as follows: menu (f) Æ parameters Æ rs232 Æ to pc Æ 9600 bds. With flow ctrl see chapter 5.2.9 from chronoprinte...
Page 9
11. Radio programming a. Synchro to a pc • switch off the radio • connect the radio to a pc (rs232) • run the program « csf50.Exe ». • check your configuration (com) • press the button [ p0 ] and switch on the radios simultaneously. The radio info should display on the software: b. Upload the config...
Page 10
C. Program frequency allows you to get up to 8 banks of 16 channels bank : n° of the bank of 16 programmed frequency text : enter name of the bank capa : nb channel available use : nb of channel used and the frequency of each cannel (for one bank): ch x-x : n° bank – n° channel rx: receiver frequenc...
Page 11
12. Technical specification general o operating temperature -25°c to +50°c o radio dimensions: 56 x 97 x 36,4mm o weight: 250g / radio o lcd screen 8 characters o frequency: 136-174 mhz (programmable) o nb channel: max. 128 channels o gap between channels: 12.5 mhz o antenna impedance: 50 ohms (sma ...
Page 12
Tag heuer professional timing 6a louis-joseph chevrolet 2300 la chaux-de-fonds switzerland tel : 032 919 8000 fax : 032 919 9026 e-mail: info@tagheuer-timing.Com http: //www.Tagheuer-timing.Com.