TAG MCLAREN AUDIO 700:7r Owner's Manual - S E T - U P
1 2
|
s e t - u p
When the 700:7r is operated in bridged mode, two amplifier channels are used to drive
each loudspeaker, for greater power output.
To use bridged modes of operation you must alter the position of the channel bridging slide
switch on the rear of the unit. This has three positions and allows you to bridge just BR and
SR to give one extra-powerful channel, or bridge both BR-SR and BL-SL to give two extra-
powerful channels.
The operation of the
LEFT, RIGHT and CENTRE channels is not affected.
The channel bridging switch is put in the middle position
marked “BR+SR”
When the BR and SR amplifiers are bridged,
the + lead of the speaker cable connects to
the BR+ output terminal, and the - lead of the
speaker cable connects to the SR+ output
terminal as shown.
To apply signal to the BR-SR bridged channel
use the upper RCA input (marked “In A”).
The lower RCA (SR in) is not used.
6 channel set-up
B r i d g i n g
It is not advisable to change the position of this switch when the amplifier is powered and connected to loudspeakers. No damage to the
amplifier will result, but you may apply an unexpectedly high level to the loudspeakers.
GRR01030.02-UK-7007r.qxd 10/22/03 3:07 PM Page 12