TAG Nomade User Manual - page 3
Nomade User’s Manual
5
Nomade User’s Manual
4
BASIC EQUIPMENT
BASIC EQUIPMENT
ON/OFF BUTTON
Use this button to switch on/off the device.
SELECTING SWITCH
NOMADE allows to select the audio signal input. This button must be on HF when
use as a wireless link and on LINE in case of use as a wired link.
1 XLR LINE INPUT
NOMADE is equipped with 1 XLR (3 pins) line input.
POWER SUPPLY INPUT
12 Volts power supply input. Allows working on AC main and battery loading of the
NOMADE. It is recommended to use the provided cable for recharge.
LINE OUT
NOMADE is equipped with 1 XLR Line output enabling connection to Xpresso or any
other sound system. To do this, connect the LINE OUT output, RCA connectors for
Xpresso or the Line output on XLR 3 pins for Flash, to the Line out of Nomade. The
sound corrections on the Master are directly linked to the NOMADE including the
volume control.
SPEAK OUT
NOMADE is equipped with an amplified jack output (diameter: 6,35) to connect
NOMADE to a passive speaker, ref: SP10, signal cable: CH15.
MASTER LEVEL
It is the general volume control output. This setting allows to balance different levels
of each input.
NEVER CONNECT MORE THAN TWO 4 OHMS SPEAKERS THIS COULD
DAMAGE THE AMPLIFIER.
L
L
CAUTION : WIRE CONNECTION
BATTERY
NOMADE is equipped with a lead 9Ah / 12V lead battery making lots of loadings and unloadings
possible. When connected on AC main the sound system can work without time limit, while char-
ging. Minimum autonomy: 3 hours, maximum: 6 hours.
It is a battery drawer allowing quick and easy replacement if necessary. To do so, unlock the two
screws and disconnect the two power threads while respecting the polarity.
CONTROL LEDS
3 GREEN LED "ON":
- The equipment is ready to work
- The battery is loaded
3 RED LED "UNLOADED BATTERY":
- Battery has reached its time limit. Estimated working time left: from 5 and 20 minutes depen-
ding on working options.
- If you have to use the equipment longer than the estimated time connect Xpresso on AC main.
No working time limit, the battery is loading simultaneously.
- If you do not have the possiblity to connect the Xpresso to AC main, you can connect the device
to a car battery (12V power cable CH15B) or to a Pack Battery with the 12 V DC input.
3 ORANGE LED "CHARGER":
- Xpresso under power, switch “ ON ”
- The internal automatic charger will increase battery tension up to its highest level +/- 13 V.
NEVER STOCK THE EQUIPMENT WITHOUT HAVING RELOADED IT. It is recom-
mended to switch of the equipment while loading to ensure a full battery recharge.
L
L
CAUTION: BATTERY LOADING