Taiji TSK-160 Instruction Manual - page 6
1. Take the unit out of the shipping carton and remove all packaging materials.
Check that all parts and accessories are included with the unit.
2. For installing, the location must have/be:
• A level and steady surface
• Sufficient space for air circulation around the unit
• Be at least 50 cm away from any heat source
• No direct sunlight
• Avoid high-humidity areas and areas near water
• Use the equipment splash condition as per “IPx5” as the minimum guideline.
3.
Initial uses:
Before operating this product for the first time, clean the interior of the
main unit by following the instructions in the “Maintenance/Daily Cleaning”
section of this manual.
4. How to change Sake feeder; Bottle Type to Cubic Container Type:
For using Cubic container type, set up the
machine as follows.
-6-
INSTALLATION
INSTALLATION
1) Loosen the Urea resin screw
and open the door. (Fig.1)
2) Remove a joint between the main unit
and Bottle holder. (Fig.2)
3) Remove two Urea resin screws and remove
the Bottle holder unit. (Fig.3)
4) Screw the Joint hose (accessory) into
the main unit.(Fig.4)
(Fig.1)
Urea Resin Screw
(Fig.2)
(Fig.3)
(Fig.4)
Joint Hose
Bottle Holder Unit
Urea Resin Screws