Tait TM8105 User Manual - Radio Installation

22 Radio Installation

Radio Installation

Mounting 

the U-bracket

Screw the U-bracket in the chosen mounting position 

using the self-tapping screws provided. At least four 

screws must be installed.

Note: If the U-bracket is being mounted over 

a curved surface, the U-bracket tabs can be 

bent slightly.

Caution: Check that the tightening of the 

screws does not distort the U-bracket.

Installing the 

Control Head 

on the Radio 

Body

The orientation of the U-bracket mounting determines 

which way up the control head is mounted on the radio 

body. The numbers in the diagram above refer to the 

numbered steps below.

1. Plug the control head loom onto the control head 

connector.

2. Insert the bottom edge of the control head onto the 

two clips in the front of the radio chassis, then snap 

into place.

2

1

2