Tait TM8105 User Manual - Removing The Control Head

Radio Installation 23

Removing the Control Head

Caution: During this procedure, take care that 

the chassis seal is not damaged. Damage to this 

seal reduces environmental protection.

1. On the underside of the radio, insert a flat-bladed 

screwdriver between the control head and the radio 

chassis seal, in either position 

 or 

.

Note: Insertion points 

 and 

 are indi-

cated on the radio chassis by a dot-dash-dot 

pattern (•

–

•).

2. Use the screwdriver to lift the control head off the 

chassis clip, then repeat in the other position.

The control head can now be removed from the 

radio body.

Installing the 

Microphone

Caution: The microphone grommet must be 

installed whenever the microphone is 

plugged into the microphone socket. When 

installed, the grommet has two functions:

■ to prevent damage to the microphone socket when 

there is movement of the microphone cord, and

■ to ensure that the control head is sealed against 

water, dust and other environmental hazards.

2

1

1

2

1

2