Taizhou Tianchen Intelligence & Electrics L2700 User Manual - page 25
6. MAINTENANCE AND STORAGE
7. To remove the deposits and/or other residues from the blade, use a
suitable brush.
8. Clean the outside of the charging station from any accumulated
residues.
9. Keep all nuts, bolts and screws tight to be sure the appliance is in
safe working condition.
10. Replace worn or damaged parts for safety.
11. Ensure that only replacement cutting means of the right type are
used.
12. Ensure that batteries are charged using the correct charger
recommended by the manufacturer.
13.Incorrect use may result in electric shock, overheating or leakage
of corrosive liquid from the battery.
14. In the event leakage of electrolyte flush with water/neutralising
agent, seek medical help if it comes into contact with the eyes
etc.
15. Servicing of the appliance should be according to
manufacturers instructions. This product (include battery pack)
must be disposed of at a designated collection pint for electrical
and electronic waste. For more information, contact your local
city office or the shop where you purchased the product.
3.Clean all the outside surfaces of the robot with a spong soaked in
warm water.
4.Do not use solvents or benzene so not to damage the varnished
surfaces and the plastic components.
5.Do not wash the inside parts of the robot and do not use water jets in
pressure so not to damage the electric and the electronic
components.
6.Check the lower part of the robot (cutting blade area and wheels)
and remove the deposits and/or residues that might obstruct the
correct functioning of the robot.
WARNING
Never use a high-pressure washer or
even running water to clean the robot.
- P43-
6. MAINTENANCE AND STORAGE
6.2 Robot Storage
Packed the mower and all spareparts with the original package, and
storage the carton off the ground in a cool, dry place. Temperature should
not be colder than - 4 F°( - 2 0℃)
6.3 Blade replacement
Blade model: 2000B
Specifications:
Blade replace steps:
1.Stop the robot in safety conditions.
2. Wear protective gloves.
3. Turn the Robot upside down.
4. Unscrew the blade and remove it.
5. Replace a new blade and screw it.
6.4 Fuse replacement
1. Press the clamshell and open it.
2. Unscrew the cap and take out the
broken Fuse.
3. Replace a new Fuse and screw the
cap.
Fuse model: 2000F
Specifications:
- P44-