Takex TMC-734D Instruction Manual - page 7
7
5)
Turn on TMC-734D, monitor and connected device etc..
●
Immediately turn off all the equipments and recheck the connection if nothing appears on a
monitor screen.
6)
Adjust the aperture and the focus of the lens while watching the screen image of the monitor..
・
Adjust the lens mount position in the following way if it has difficulty in focusing (e.g., by using
non-standard lens).
7)
Select the electronic shutter speed to suit the intended use by the
⑭
shutter switch as needed.
8) S
elect the white balance mode to suit the intended use by the
⑩
W.B selector switch as needed.
Adjusting method of Lens mount position
・Mount the lens used and loosen all three hex-head screws③.
・Move the lens mount back and forth and focus a camera on the far point with the lens focus of infinite distance.
・Tighten all three hex-head screws at the point where it comes into focus.
Cautionary notes about Electronic shutter
・Smear may appear when the intense light falls onto the CCD imaging area in E.I(Electronic iris) and high speed
shutter mode. (it is not the camera-related failure.)
・The flickering phenomennon may occur at commercial power frequency in the lighting environment such as
fluorescent lamp or mercury lamp. If the phenomenon gets to a serious extent, use the camera with ⑭Shutter
switch turned OFF.(In this case, it is recommended to concurrently use Auto iris lens.)
A high-frequency lighting may also contribute to reduce the phenomenon.
・The flickerless function(F.L) is the effective function to reduce a perceptible flicker. It is effective only at 50Hz
commercial frequency area for NTSC standard monitor.
Cautionary notes about White balance mode
・AUTO tracking mode(AUTO) or Push-lock white balance mode(P.W.B) is efficient way to take a white balance
under the luminous surroundings where it is difficult to take a white balance in the preset mode (Light bulb mode,
Fluorescent light mode1, Fluorescent light mode2).
・It is effective to employ AUTO tracking mode(AUTO) where the lighting environment varies with time
(cf.around-the-clock monitoring) However a white balance may not properly be taken under the luminous
surroundings where the amount of light is extremely low or the flicker emission is very high.
・Adjustment of white balance in P.W.B mode is more efficient by doing it while capturing the white object and
displaying it in full-screen.
・In P.W.B mode, a white balance can be set in most luminous surroundings but it has not the function to auto
tracking the variation of luminous surrounding.(It is needed to manipulate a W/B adjust button(B) in each case.)