Takstar X6 User Manual - page 6
5mW
BAT
5
6
Button function and operation
1) Short press “SCAN” button for automatic frequency scan and “ACT” for automatic frequency
2) Long press “SCAN” for manual adjustment mode, and long press “ACT” for function key locking.
LCD panel instruction
Under the initial interface as picture 1, short press “SCAN” button for automatic channel scan.
When stop scanning, it will finish channel selection.
Under the initial interface as picture 1, long press “SCAN” button, the LED will glitter, indicates
manual frequency adjustment status; Short press or long press “ACT” or “SCAN” button for
adjusting the channel. Once loosen the button, the LED will glitter 5 seconds and stop, it means
channel adjustment is finished.
A. Channel/frequency indication and adjustment
1. Automatic channel scan mode
2. Manual frequency adjustment mode
B. Infrared frequency matching
1. Under the initial interface as picture 1, select the channel, turn on the transmitter and point the
“IR” frequency reception window to the “IR” frequency window on the receiver in line (distance
between transmitter and receiver is 10CM-30CM); short press “ACT” button, the LED indication
as picture 2 will automatically change into the actual frequency/channel display interface after
successfully transmitting the frequency. If it fails, it will show the LED indication as picture 3,
short press “ACT” to continue the frequency matching until it succeeds.
Picture 1
Picture 2
Picture 3
Picture 4
Picture 5
Picture 6
Picture 7
C. System locking
1. Under the initial interface as picture 1, long press “ACT” for function key locking. When locking
is finished, it will show the LED indication as picture 4 and all function key will be locked (except
power button and frequency matching button). Long press “ACT” button for unlocking and it will
show the interface as picture 5.
D. Power off
1. Long press “POWER” for power off and LCD indicator will show the interface as picture 6
E. LCD indicator of microphone
1. When the microphone is powered on, the LCD will light (like picture 7) and it indicates curent
channel, RF strength and battery power level. For changing the channel, please first change the
receiver channel, then point the infrared frequency window of transmitter and receiver to each
other. Then press the “ACT” button on receiver, the new channel specification signal will be
transmitted to the transmitter.
2
.
3
.
matching.