Takumi K-10 Owner's Manual - page 2
Thank you
We extend our hand in deep gratitude, thanking you for selecting the Takumi K-10 pre-amplifier.
This pre-amplifier is easy to install and use but there are some precautions that need to be observed
in order to attain maximum performance, safety and reliability. Please therefore read carefully thru
this owner’ s manual before installing your K-10.
If there any doubts in your mind or should you require any supplementary information, please do not
hesitate to contact your distributor or Robert Koda directly.
Cordially,
Robert Koch.
Important safety information
This unit is designed to be earthed.
Please therefore ensure that the AC power cable you select to use with the K-10 is a three wire type
that is earthed. Failure to do so may render a potentially dangerous situation.
There are no user serviceable parts inside. Please therefore do not attempt to open, adjust or modify
this pre-amplifier.
Power up and power down sequence.
Due to the fact that the K-10 does not incorporate power up / down muting circuits, a large pulse
may be emitted from the speakers if the pre-amplifier is not powered up or down in the correct
sequence. This pulse may be objectionable or even damaging to your loudspeakers and in particular
active bass systems so please:
On power up, turn the pre-amplifier on twenty seconds or more before the power amplifier(s).
On power down, turn off the power amplifiers before turning off the pre-amplifier.
Takumi K-10 Owner's guide
1