Talent LM-1 User Manual - page 4
Never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a
fuse of the same type and electrical specifications!
In the event of serious operating problems, stop using the fixture and contact your
dealer immediately.
The housing must be replaced if
it is visibly damaged.
Please use the original pack
aging when the device is to be transported.
Due to safety reasons
, it is prohibited to make unauthorized modifications to the unit.
DESCRIPTION:
1.
FOG FLUID CONTAINER:
Fill with CE-certified smoke fluid. Make sure that
the fog fluid container is never empty during operation, this will damage the pump
of the fogger.
2.
FLUID LEVEL INDICATOR:
Indicates how much fog fluid is still available.
3.
NOZZLE:
Fog output. WARNING: HOT! Observe a minimum distance of 3 feet.
4.
REMOTE CONTROL INPUT: Use to connect the supplied remote control
.
5.
INPUT FUSE:
If
the fuse is blown, first
locate and solve the
problem that caused
the fuse to
blow.
When the
problem is solved,
replace a damaged
fuse with a fuse of the
same type and
electrical specifications.
6.
POWER CABLE
7.
POWER SWITCH
OPERATING INSTRUCTIONS
P
lace the fogger on a flat, stable surface. Ensure that nobody places their
hands in front of the output
nozzle. The fog is very hot and can cause serious burns!!!
Ensure the fog liquid tank is not empty. Always use good quality fog liquid to fill up
the tank.Close tank immediarely to prevent dirt to enter the reservoir!
Plug the supplied remote in
to the remote control input (4) on the back of the unit. Do not
insert or remove the remot
e while the fogger is connected to a power outlet.
Ensure to plug the fogger
in
to a power receptacle that
is connected to ground.
Switch the fogger on and wait
for about 4 minutes
to allow
t
he fogger to warm up.
Use
of the supplied remote
control:
1. REMOTE CABLE:
Connect the
special 3
-pin connector to the remote