Talent LM-1 User Manual - page 5
input on the back of the fogger(4).
2. MANUAL FOGGING BUTTION:
As long as the red LED is on, you can press this
button at any time to produce fog.
MAINTENANCE
Switch off the unit
, unplug the main power cable, and wait until the unit has cooled.
During inspection the following points should be checked:
All screws used for installing the device and any of its parts should be tightly fastened
and
are not corroded.
Housings
and fixed installation spots (celling, truss, suspensions) should be totally
free from any deformation.
The main
power cables must be in perfect condition and should be replaced immediately
when even a small problem is d
iscovered.
Cleaning the fogger:
To prevent obstructions in the heater, pump and tubes, the fogger should be cleaned on a
regular basis
. Every 100 hours of continuous operation is a good reference.
Switch the fogger off.
Remove the nozzle (metal part where the fog leaves the fogger).
Remove the fog liquid from the tank.
Fill the tank with about 1
liter of solution containing 80% distilled water and 20% white
vinegar.
Switch the fogger on and wait for about 8
minutes (warm up time).
Put the fogger in continuous operation mode until the tank is empty.
Put the nozzle back in place.
Completely clean the cleaning solution out of the tank and refill it with fog liquid.
Note: Cleaning should be done outside: an unpleasant smell is produced by the vinegar solution!
Attention:
We strongly recommend internal cleaning to be carried out by qualified personnel!