Talkswitch owner friendly Specifications Manual - page 20
V S H A R D W A R E S P E C I F I C A T I O N G U I D E
1 6
IMPORTANT NOTICES
CE Compliance
The product models listed below comply with the essential requirements of the European “Radio and
Telecom Terminal Equipment” (R&TTE) directive 1999/5/EC, and are for connection to regular telephone
lines (PSTN).This equipment has been tested and found to comply with the following standards:
EN55022:1998 + amendment A1:2000 + amendment A2:2003, Class B
EN55024:1998 + amendment A1:2001 + amendment A2:2003
EN60950–1:2001, first edition
EN61000–3-2:2000
EN61000–3-3:1995+ amendment A1:2001
CISPR22:1997 + amendment A1:2000 + amendment A2:2002
FCC and IC Warnings
This equipment complies with ACTA TIA/EIA/IS-968A and Part 68 of the Federal Communications
Commission (FCC) rules in the United States. It also complies with regulations RSS210 and CS-03 of
Industry Canada and Science Canada. This equipment also complies with Part 15 of the FCC Rules, as well
as ICES003 of Industry Canada. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation of the device.
FCC Part 15
This equipment has been tested and found to comply with the limits for a “CLASS B” Digital Device
pursuant to Part 15 of the FCC rules. These limits are designed to provide a reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in accordance with these instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different to that which the receiver is connected.
•
Consult the dealer or an experienced Radio/TV technician for help.
This equipment is marked with the CE symbol,
indicating compliance with CE standards.
This CLASS B Digital apparatus meets all requirements of the Canadian interference-causing equipment
regulations.
Changes or modifications not expressly approved by FortiVoice could void the user’s authority to
operate the equipment.