Tally T5023+ Programming Manual - page 242
Status and error messages
Additional commands (Printer)
232
T5023/5023+ - Programming Guide
Function:
Special printer messages are produced in the following cases and transferred to
the system:
–
when changing the appropriate statuses
–
when using the keys USER 2 or USER 1 via the operator (only if the function
’Dual station control’ was activated using the command CSI n * t)
Further, the current status can be requested using the command CSI " z.
The following n/m combinations for the encryption of a special printer message
are possible
:
PAPER
n = 1 / m = 4
The paper sensor on the document printing point is covered
with paper again.
NO PAPER
n = 2 / m = 4
The paper sensor on the document printing point is no
longer covered with paper.
USER 1
key
n = 20 / m 1
The USER 1 key on the operating panel was pressed.
This printer message can only occur if the function ’Dual
station control’ was activated using the command CSI n * t.
USER 2 key
n = 20 / m = 2
The USER 2 key on the operating panel was pressed.
This printer message can only occur of the function ’Dual
station control’ was activated using the command CSI n * t.