6306 / 6312 unpacking/installation.
Unpacking step 1. Cut the shipping bands. Step 2. Open the top of the box and remove the accessories and the foam end caps. Step 3. Lift the cardboard box off the printer. Steps 4 & 5. Using a 9/16" socket wrench, remove two bolts. Step 6. Remove the block from under the pallet. Step 7. Remove shipp...
Shipping hardware removing the shipping hardware there are 4 screws, identified by red tags, that secure the printer base to the inside mechanism. The upper 2 shipping screws have wing-heads which tighten a bracket against the platen. The lower 2 shipping screws fasten from underneath, near the fron...
Installing rear paper guide the rear paper guide has two parts. Separate them and attach the lower part to the back of the printer with two existing phillips-head screws. Setting up paper stacking chains paper exits the print area through a set of passive paper stacking chains that help fold and sta...
Interface and power connections serial/parallel the serial interface operates up to 38.4 kbaud and uses a standard db-25 serial cable connector and standard rs-232-c signals. The centronics parallel port is ieee-1284 compliant and uses a 36-pin 1284-b type connector (amp 555119-1 or equivalent). To ...
Installing the ribbon step 1. Make sure the printer is offline or power is off. Open the printer lid. Step 2. Remove slack in the ribbon by turning the knob on the ribbon cartridge as indicated by the arrow next to the knob, then slip the ribbon, left side first, over the two ribbon guides and betwe...
Loading paper step 1. Raise the printer lid and open the doors on both tractors. Step 2. Place the stack of paper inside the cabinet on the floor and feed the paper up through the paper slot, a little ways past the tractors and through the gap between the top back of the printer and the lid. It will...
Step 4. The column alignment scale is on the top of the hammer bank housing. Column 1 of pre-printed forms or the left-hand perforation of plain paper should be aligned with the mark on the scale the forms creator has designated. Step 5. Unlock the right tractor and move it so that the paper's holes...
Step 6. Set the top of the form (tof). This is done from the control panel. If the printer is not on, turn it on now. Press the online key until "offline" is displayed. Use the up or down arrows to move the perforation line on the paper to be aligned with the nubbin on the tractor door. Once the pap...
Testing the printer you can use the help menu printout to test the printer. How to print a help menu printout the organization of the multilevel menus is shown on the help menu printout. All current selections are marked with an asterisk. 1. Make sure the printer is offline. 2. Press the menu key. 3...
