1. DL manuals
  2. TAMASHI
  3. Car Receiver
  4. XTD-168USB
  5. User Manual And Installation Instructions

TAMASHI XTD-168USB User Manual And Installation Instructions

Manual is about: CD/MP3/WMA/SD/USB/AUX CAR RADIO

Summary of XTD-168USB

  • Page 1

    User manual and installation instructions fm stereo radio rds (radio data system) function anti-shock mechanism telephone mute function 4x25 w high power output cd/mp3/wma/sd/usb/aux car radio disp eq band loud ams mod 1 2 scn 3 rpt 4 shf 5 6 ta af pty reg aux loud mono eq pop rock class st d-aud d-...

  • Page 2

    Gb-1 contents contents...............................................................................................................................................Gb-1 accessories..........................................................................................................................

  • Page 3

    Accessories gb-2 mounting bracket (half sleeve) x 1 removable trim ring equipped on the unit x 1 small metal strip x 1 plain washer x 1 spring washer x 2 tapping screw x 1 screw x 4 hex nut x 1 mounting bolt x 1 release key x 2 iso wire connector x 1 protective case x 1 removable control panel x 1 u...

  • Page 4

    This unit is designed and manufactured with the user’s safety in mind, however any improper use or operation may result in certain dangers. It is therefore highly recommended to read this manual thoroughly and adhere to the following precautions. To prevent an electrical shock, do not open the housi...

  • Page 5

    Installation notes: - choose the mounting location where the unit will not interfere with the normal driving function of the driver. - before finally installing the unit, connect the wiring and make sure that the unit works properly. - consult with your nearest dealer if installation requires the dr...

  • Page 6

    Installing the unit be sure you test all connections first, and then follow these steps to install the unit. 1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal. 2. Disconnect the wire harness and the antenna. 3. Press the open ( ) ...

  • Page 7

    9. Slide the unit into the sleeve until it locks into place. Ensure that you install the short part of the threading to the back of the unit and the long part to the metal strap. 10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the ...

  • Page 8

    Using the detachable front panel removing and protecting detachable front panel the front panel of the unit may be removed as a theft deterrent. After removing the front panel, use the case provided to keep the front panel from getting damaged. 1 press the open button to flip down the front panel. ....

  • Page 9

    Wiring diagram antenna socket l r fuse iso connector gb-8 iso connector: part a: a1: a2: a3: a4: a5: a6: a7: a8: part b: b1: b2: b3: b4: b5: b6: b7: b8: no connect no connect no connect battery b+ (yellow) antenna (blue) no connect accessory (red) ground b- (black) rear right + (violet) rear right -...

  • Page 10

    Operations location and function of keys front panel : the front facet after removing the front panel: descriptions of function controls gb-9 (1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11) (12) (13) (14) (15) (16) (17) (18) (19) (20) (21) (22) (23) (24) (25) (26) (27) (28) power on/off ( ) button lcd...

  • Page 11

    Reset the unit power on/off 1.Turn off the unit power. 2.Press the ( ) button and remove the front panel, then press the button with a ballpoint pen or similar object to restore the unit to the original factory settings. In power off mode, switch on the unit by pressing any button except the button ...

  • Page 12

    “ta seek or ta alarm” (search for traffic announcement/traffic announcement alarm) - ta seek (traffic announcement search) mode: - ta alarm mode: note: “pi sound or pi mute”: “retune l or retune s” (long/short retune): retune l mode: - retune s mode: - mask dpi mode: mask all mode: when a newly tune...

  • Page 13

    "beeps 2 ”, “beep all”, “beep off” nd the car audio device is equipped with 3 beep tone modes. - beep mode: the beep sound is on when any key is pressed. - beep off mode: the beep sound is disabled. In power on mode, press button repeatedly to select the different modes in the following sequence: ra...

  • Page 14

    Tel mute the audio system automatically mutes whenever a telephone call comes in. Note: the function will not work if a cable is not connected to the car phone. When a call is received, 'tel call' is displayed and all the unit functions are temporarily interrupted. Hang up the phone. 'tel call' disa...

  • Page 15

    Radio operations press the button to select the radio mode. One of the three you can store up to a total of 18 radio stations in the memory (18 fm), manually or automatically. - select a band (if needed) - select a station by or buttons, refer to auto / manual tuning. - hold a preset button ( - ) fo...

  • Page 16

    The rds data are the pi, ps, tp, pty, ta and af data. Setting af mode regional program operation some broadcasting stations change their program from normal broadcasting to regional broadcasting for a certain time period. When region is on, the current listening program remains unchanged. When regio...

  • Page 17

    Using pty to select a program the pty function allows you to search for a particular program type. To select a program type, press the button. “pop m” (pop music) or “news” will appear on the lcd display. You can then select a program type using the preset buttons to . The program types are divided ...

  • Page 18

    Cd/mp3/wma disc operations press the button to select the disc mode. 1. Press the ( ) button on the front panel to flip down the front panel and then insert a disc into the disc slot with the printed side facing upward; and close the front panel, the player will play the disc automatically. 2.To eje...

  • Page 19

    Gb-18 how to select a file in mp3/wma mode: there are four ways to access a file in mp3/wma mode: a press the button once to access the track number search mode. The message “mp3 t ” will be shown on the lcd display and the “ ” symbol will blink b rotate the to select a file number. Then press the b...

  • Page 20

    Gb-19 d after you have press the button to confirm. The unit searches for files and directories which have the same character as the one which you entered. E the volume/select button to select a file. Finally, press the button to confirm and play the selected track. Press the button three times to a...

  • Page 21

    Gb-20 using the sd/mmc card: mode note: when you insert a sd/mmc card into the memory card slot, the player will read the sd/mmc card automatically. If you insert a disc into the disc slot while reading the sd/mmc card, the unit will play the disc. You can press button to select sd/mmc mode. Sd/mmc ...

  • Page 22

    Using the usb stick: mode note: when you insert a usb stick through the port, the unit will search for the mp3/wma files and start to play them automatically. If you insert a disc into the disc slot while reading the usb stick, the unit will play the disc. You can press button to select usb mode. - ...

  • Page 23

    Gb-22 2. The unit cannot play a cd-r and cd-rw that is not finalized. (please refer to the manual of your cd-r/cd-rw recorder or cd-r/cd-rw software for more information on finalization process). 3. Depending on the recording status, conditions of the disc and the equipment used for the recording, s...

  • Page 24

    3. Near car heaters. 4. On the seats or dashboard. Use a dry soft cloth to wipe the surface. If the disc is quite dirty, use a soft cloth slightly moistures with isopropyl (rubbing) alcohol. Never use solvents such as benzene, thinner or conventional record cleaners as they may the surface of the di...

  • Page 25

    1. General 2. Cd player 3. Radio fm 4.Usb/sd/mmc card power supply requirements.............................Dc 12 volts, negative ground unit dimensions...................................................178(w)x160(d)x 50(h) mm tone controls.........................................................- b...

  • Page 26

    Symptom cause solution no power the car ignition switch is not on. Turn the ignition key to “accessory” in order to switch the unit on. The fuse at the back of unit has been blown. Check the connections. Presence of cd disc inside the player. Remove the disc from the player, and insert a new one. Di...

  • Page 27

    If at any time in the futu e you should need to dispose of this product, please note that waste electrical product should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice. (waste electrical and electronic...