Tamerica TCC-2700 Operating Instructions Manual - page 6

FILM THICKNES

TEMPERATURE

SPEED

1.5Mil (38 Micron)

3Mil (75 Micron)

5Mil (125 Micron)

10Mil (250 Micron)

110°C/230°F

110°C/230°F

25°C/257°F

135°C/275°F

4

3

3

3

HEAT & SPEED ADJUSTMENT TCC-2700

1. 

Turn on the power switch, the digital screen display will show the previous temperature setting. 

Please set the temperature to 90°C(l94F) to start the heat process. By pressing

the "-.."or .. __. .. key of the "TEMP/SET", users can re-set the temperature. The lowest temperature this 

machine can be set is 90°C (194°F). The digital screen display will beep showing the set temperature for 

3 seconds. After that, it will show the actual machine temperature.

2. 

Press the "HOT" key for heating once the temperature is set and the heater light will glow.

3. 

The machine will buzz/beep once it reaches 80°C ( l 76°F) for at least 3 minutes. This is to

alert the user that machine will start running. You can stop the beep by setting the motor

speed to 1.

4. 

Press the "-.."or"_.," key of "MOTOR" to set the motor speed for lamination. The table °C below 

gives some common temperature/speed setting for typical uses.

Notes:

If the machine is left unattended and the motor speed is not adjusted, the machine will stop in approxi-

mately 3 minutes. This feature protects the Hot Rollers as they must constantly turn while the heal is on.