Tan.Easy TAN.LITE 32000 Operation Manual - page 5
WASHING YOUR TURBINE FILTER
HANDY TAN
IMPORTANT!
We recommend doing this over a sink or towel.
SPRAY MACHINE
EXTERNAL SOLUTION CUP
AIR HOSE
Rinse your solution cup with warm water
until clean. Wipe all areas dry ready for
the next use.
Please note: We recommend washing
your cup under water, each time you
remove the cup from the handy tan and
refill. If you have spilled the contents of
the cup and product gets in the screw-
band (grooved area of the cup being
screwed into the HandyTan) simply wipe
the grooves with Tan.Easy Cleaning
Wipes or a wet cloth/paper towel. This
will allow the cup to be easily tightened
back onto the Handy.Tan and cause the
cup not to leak excess spray solution.
Wipe the Air Hose daily with Tan.Easy
Cleaning Wipes. Alternatively use a damp
cloth. Once dry, store in a clean dry place.
CLEANING & MAINTENANCE:
IMPORTANT
WASH TUBRINE FILTER
WITH WATER AT LEAST
EVERY 6 MONTHS
If the spray machine gets dirty with
overspray solution, wipe down with
Tan.Easy Cleaning Wipes. Alternative-
ly you can use a smooth cloth (avoid
anything abrasive) with a general glass
cleaner to maintain the gloss finish.
WARNING: ALWAYS UNPLUG
THE DEVICE BEFORE CLEANING.
The only maintenance necessary on the Tan.Lite device
is cleaning or changing the turbine filter.
1. Remove the turbine filter from the filter housing
located above the air hose ‘Turn&Lock’ screw connect.
2. Wash under cold water. Do not use detergents to
clean the filter.
3. Please leave to dry completely.
Consideration: The filter may require more frequent washing if product
is located close to spraying.
Please Note: We recommend your spray machine be placed a minimum of 50cm
behind you. This ensures minimum cleaning with your machine. HVLP technology
recirculates air from the environment. With your machine by your side, spray tan
solution will be sucked back into the filter of your spray machine, clogging up the
filter in the machine, meaning more frequent cleaning. Positioning the spray unit
behind you will ensure the unit stays cleaner for longer.
IMPORTANT!
It is important to check your filter and wash at least every 6 months,
according to instructions, to maintain performance. Do not put the filter in a
dishwasher, washing machine, tumble dryer, oven, microwave or near a naked
flame.
1. Remove the hose from the Handy.Tan.
2. Unscrew the cup from the Handy.Tan and empty any
un-used solution from the cup.
3. Rinse the empty solution cup with warm water until clean
and then fill the cup about ¼ full of warm water.
4. Insert the cup and screw tightly, back into the Handy.Tan
and re-connect the hose.
5. Turn on your spray tan machine and adjust your solution
Flow Control dial to the highest setting for maximum
water spraying.
6. Direct the spray applicator into the sink and spray the clean
water through until the cup is empty. This will clean through
the needle and out to the spray-pattern nozzle.
7. Now that the cup is empty, re-set your solution Flow
Control dial on the back of the Handy.Tan to your
regular settings.
8. Disconnect the Handy.Tan from the Air-Hose and unscrew
the cup.
9. Wipe all areas dry including the cup and Handy.Tan ready
for the next use.
IMPORTANT!
You must not submerge the Handy.Tan under water.
If your handy tan has excess spray solution, wipe down with Tan.
Easy Clean Wipes. Alternately you can use a smooth cloth
(avoid anything abrasive) with a general glass cleaner to
maintain the gloss finish.