TANDBERG 2U AUTOLOADER Quick Start Manual

Summary of 2U AUTOLOADER

  • Page 1

    1 rev. 1.0, june 2004 2u autoloader quick start guide step 1: unpack the autoloader a. Look for markings on the shipping carton that indicate the top. If necessary, position the carton so that it is top-side up. B. Using scissors, a utility knife, or other appropriate tool, carefully cut the packing...

  • Page 2

    2 rev. 1.0, june 2004 step 2: choose a location select a location for the autoloader that has adequate clearance for ventilation, minimal dust and debris, and an appropriate power source nearby. If this is a standalone installation, select a location that is flat, sturdy, and level. Do not place the...

  • Page 3

    3 rev. 1.0, june 2004 step 4: cabling the autoloader a. Ensure that all devices on the scsi bus are powered off. B. Attach a scsi cable from the scsi bus to one of the scsi connectors on the back panel of the autoloader. C. If the autoloader is the last device on the scsi bus (or the only device), a...

  • Page 4

    4 rev. 1.0, june 2004 step 6: turn on the autoloader turn on the autoloader by pressing the power button on the front panel. Power on the host and all attached scsi devices. Use the eraser end of a pencil or something similar to press the left side of the power switch. The autoloader powers up. Step...

  • Page 5

    5 rev. 1.0, june 2004 6. Repeat step 4 to 7, until all cartridges are imported. Drive empty 12345678 seq 7. Power up your host computer. 8. Verify your backup software. Exporting cartridges. Unload tape cartridges from the autoloader by using the export command from the front panel. The selected car...

  • Page 6

    6 rev. 1.0, june 2004.

  • Page 7

    7 rev. 1.0, june 2004 support contact information: europe tandberg data gmbh feldstr. 81 d-44141 dortmund germany phone: 0049 – (0)231 – 5436 142 fax: 0049 – (0)231 – 5436 143 usa inostor inc. (a tandberg data company) 13000 gregg street poway ca 92064 usa phone: 001 – (0)858 – 726 0277 fax: 001 – (...