TANDBERG 2U AUTOLOADER Quick Start Manual - page 4
4
Rev. 1.0, June 2004
Step 6: Turn on the Autoloader
Turn on the Autoloader by pressing the power button on the front
panel. Power on the host and all attached SCSI devices.
Use the eraser end of a pencil or something similar to press the left
side of the power switch. The autoloader powers up.
Step 6: Operating the Autoloader
The following sections provide an overview of Autoloader
operations.
Importing Cartridges.
Load tapes into the Autoloader by using the Import command from
the front panel and then inserting the data cartridge into the
mailslot.
Install data cartridges in slots 1-8:
1. Place cartridge in the cartridge access port.
2. Press any button on the operator panel to change to interaction
mode.
3. Choose the "Commands" menu and press
4. Choose "Import", press
5. Enter the number of the cartridge slot and press
The cartridge is placed in the chosen slot.