Tandberg data dlt vs160 storageloader tm quick installation guide tandberg data asa p.O. Box 134 kjelsås n-0411 oslo, norway phone + 47 22 18 90 90 telefax + 47 22 18 95 50 © tandberg data asa part no. 433241-01 dezember 2004.
Related publications available from tandberg data asa: part no. Title 433060-01 tandberg data storageloader installation and user manual 433061-01 tandberg data storageloader scsi interface functional specifications. 432679-01 tandberg data dlt vs160 installation and operation manual this publicatio...
Table of contents introduction ........................................................................................................ 4 front panel of the storageloader ................................................................ 5 unpacking the storageloader .....................................
Tandberg data storageloader 4 storageloader quick installation guide introduction this guide is designed to act as a guideline to enable quick installation of the tandberg storageloader series. For additional product and operation details please refer to the tandberg data dlt vs160 storageloader ins...
Tandberg data storageloader storageloader quick installation guide 5 front panel of the storageloader magazine front bezel led indicators soft power switch lcd display control buttons magazine front bezel unpacking the storageloader carefully unpack the unit from the shipping container. Save the con...
Tandberg data storageloader 6 storageloader quick installation guide removing the transport lock the robot mechanism is protected from damage during shipment with a screw mounted through the display unit bracket into the robot assembly. The screw is marked with a red plastic tab protruding between t...
Tandberg data storageloader storageloader quick installation guide 7 rack installation this storageloader is designed for use in 19” rack system using 1u of rack space. The weight of the unit and the length of the power cord and the scsi cable restrict the placement. We recommend that you mount the ...
Tandberg data storageloader 8 storageloader quick installation guide installing the rack mounting kit caution: consider rack stability when deciding where to place the storageloader! Storageloader 1u uses 1u of vertical rack space. The rails must be installed in a full u position (the bottom of the ...
Tandberg data storageloader storageloader quick installation guide 9 installing the rail right assembly follow the instruction for left side only using the “rail right assembly ” on the right side of the rack. Picture showing step 5 above: rack mounting kit mounted in rack with one screw m6x12 in up...
Tandberg data storageloader 10 storageloader quick installation guide mounting the storageloader to the rack make sure that all the screws in the rack mounting kit are tightened properly before installing the storageloader in the rack. Slide the storageloader on the rack mounting kit from the front ...
Tandberg data storageloader storageloader quick installation guide 11 installing the scsi adapter the storageloader makes use of a standard scsi vhdc interface connector (also known as a miniature scsi connector). In general most “adaptec compatible hba’a may be used”. Please refer to the installati...
Tandberg data storageloader 12 storageloader quick installation guide 4. Watch the display on the front of the autoloader as it powers up. The storageloader will flash messages as it performs its internal tests and then return a ready message when the test has completed successfully. The word idle a...
Tandberg data storageloader storageloader quick installation guide 13 ▲ exit loader scsi id ▼ select ▲ exit drive scsi id ▼ select to set the scsi addresses for the storageloader and the built in tape drive, refer to the user and installation manual for more information. You may also wish to reserve...
