TANDBERG E20 Administrator's Manual - page 34
D14330.09 TANDBERG E20 ADMINISTRATOR GUIDE (TE2.1) February 2010
34
What’s in this Guide?
Introduction
Deploying E20
Using E20
The Settings
Advanced settings
Advanced Settings
inform the SNMP Manager about important events. Can be used to send
event created messages to the SNMP agent about different events like:
system reboot, system dialing, system disconnecting, MCU call, packet
loss etc. Traps can be sent to multiple SNMP Trap Hosts.
Mode
Off: Set to Off when you want to disable the SNMP network
service.
ReadOnly: Set to ReadOnly when you want to enable the SNMP
network service for queries only.
ReadWrite: Set to ReadOnly when you want to enable the SNMP
network service for both queries and commands.
System contact
Enter the name of the Network Services SNMP System Contact.
System location
Enter the name of the Network Services SNMP System Location.
SIP
Determines whether the system should be able to place and receive SIP
calls.
On: Set to On to enable the possibility to place and receive SIP
calls. This is the default setting.
Off: Set to Off to disable the possibility to place and receive SIP calls.
NTP (Network Time Protocol)
The Network Time Protocol (NTP) is used to synchronize the time
of the system with a reference time server. The time server will
subsequently be queried every 24th hour for time updates. The time
will be displayed on the top of the screen. The system will use the
time to timestamp messages transmitted to Gatekeepers or Border
Controllers requiring H.235 authentication. The system will use the
time to timestamp messages transmitted to Gatekeepers or Border
Controllers that requires H.235 authentication. It is also used for
timestamping Placed Calls, Missed Calls and Received Calls.
Auto: The system will use the NTP server, by which address is
supplied from the DHCP server in the network. If no DHCP server
is used, or the DHCP server does not provide the system with a
NTP server address, the system will use the static defined NTP
server address specified by the user.
Manual: The system will always use the static defined NTP server
address specified by the user.
Phonebook
ID: Enter a name for the external phonebook. Addresses the
specific phonebook.
Type: Can be TMS (TANDBERG Management System) or VCS
(Video Communication Server)
URL: Enter the address (URL) to the external phonebook server.
Addresses the specific phonebook server.
Provisioning
Provides the possibility of managing the E20 by using an external
manager/management system.
External Manager
Address: Enter the name for the provisioning server.
Protocol: http or https
Path: Enter the path within the external manager to access the
provisioning information (if http-based provisioning.)
Domain: Enter the domain of the provisioning server