TANDBERG E20 Administrator's Manual - page 36
D14330.09 TANDBERG E20 ADMINISTRATOR GUIDE (TE2.1) February 2010
36
What’s in this Guide?
Introduction
Deploying E20
Using E20
The Settings
Advanced settings
Advanced Settings
Type
Enables SIP extensions and special behaviour for a vendor or
provider.
Standard: Should be used when registering to standard SIP
proxy like OpenSer.
Alcatel: Must be used when registering to a Alcatel-Lucent
OmniPCX Enterprise R7 or later.
Avaya: Must be used when registered to a Avaya
Communication Manager.
Cisco: Must be used when registering to a Cisco CallManager
version 5 or later.
Microsoft: Must be used when registering to a Microsoft LCS
or OCS server.
Nortel: Must be used when registering to a Nortel MCS 5100 or
MCS 5200 PBX.
Siemens: Must be used when registering to a Siemens HiPath
8000.
Broadsoft: Must be used when registering to a Broadsoft
server.
Outbound: Off
Not used in this version
Mailbox
SIP URI of media mailbox (i.e. voicemail, videomail).
MultiWay conference
Name of the MultiWay conference.
Line
Select between Private and Shared. Private lines are regular SIP-
profiles similar to the line concept in TE 2.0 and earlier versions.
A shared line is a BroadWorks extension that is supported in TE
2.1. It means that several users (E20s with TE 2.1) can share a
line. Whenever someone calls the shared line, all of the E20s that
configured with the shared line will start ring. Whoever answers
first will take the call. However, it is possible for other users of the
shared line to barge-in and join the call. Since Broadworks does not
support video mixing in the current version, the joined call will be
audio only. Once one of the users disconnects from the call, the
video is resumed.
URI
Key in the URI of the E20 unit.
Proxy 1
Address: The Proxy Address is the manually configured address
for the outbound proxy. It is possible to use a fully qualified domain
name, or an IP address. The default port is 5060 for TCP and UDP
but another can be provided.
Discovery: When Manual is selected, the manually configured
SIP Proxy address will be used. When Auto is selected, the SIP
Proxy address is obtained using Dynamic Host Configuration
Protocol (DHCP).
Proxy 2–4
Identical to Proxy 1.
Authentication 1
Login name: This is the user name part of the credentials used to
authenticate towards the SIP proxy.
Password: This is the password part of the credentials used to
authenticate towards the SIP proxy.