TANDBERG FieldView Quick Start Manual - page 2
Charging the Battery
Important:
Before using this device for the first time you must install and charge the battery. The device will not
operate on the external adapter alone. You must have a battery installed.
!
"
#
$
Slide the lock switch to the
Locked
position.
Connect the FieldView
Device to the external power
adapter and charge the
battery until the orange LED
turns off (up to 8 hours).
Gap
Close the battery door as follows:
Ensure lock switch is in the
•
Unlocked
position.
Orient the battery door so it
•
is flat against the battery
well, but with a 3 mm gap.
Slide the door toward the
•
centre of the FieldView Device
until it is fully closed.
Open the battery
compartment and insert
the battery until it clicks
into place and is flush.
It fits one way only.
Unlocked
Locked
Slide the lock switch to
the
Unlocked
position.
Unlocked
Locked
1
16
3
2
7
.0
2