TANDBERG MSERIES FC Quick Reference Manual - page 2
STEP 2:
INSTALL FC420 BRIDGE(S)
a.
Turn off the library.
b.
To install/replace the first FC420 bridge,
loosen the captive screws securing the
primary electronics module, and then
slide the module out using the handle.
c.
If you are installing/replacing a second
or third FC420 bridge, remove the six
screws that secure the auxiliary
electronics module to the library back
panel. Save the screws.
d.
Prepare the expansion slot(s) required
for the installation.
If this is a first-time installation,
remove the hold-down clamp from the
top of the primary electronics module.
Save this clamp for reinstallation later.
Also remove the cover plate from each
slot required for the installation. If
desired, save the cover plate(s) for
future use.
If you are replacing an FC420 bridge,
note the location of all cable connections, and then remove all cables from the defective FC420. Then,
remove and set aside the hold-down clamp. Finally, remove the screws that secure the FC420 to the card
cage and lift the FC420 out of the library expansion slot. Save the hold-down clamp for reinstallation.
e.
Insert the FC420 bridge(s) into the expansion slot(s) prepared in
step 2d
. Press down gently on the card edge
until each card is securely seated.
f.
Repeat
step 2e
until all FC420 bridges have been installed.
g.
Secure each FC420 bridge to the electronics module frame using the screws provided.
h.
To secure the primary electronics module, reattach the hold-down clamp and then slide the module back into the
library, securing it by tightening the captive screws.
i.
To secure the auxiliary electronics module, insert the module into the library and secure it to the back panel
using the six screws removed in
step 2c
.
Mounting
screws
(6 total;
3 per side
M-2500 Library Back Panel
Auxiliary
electronics
module
Slots for
additional
FC420
bridges
Captive
screws
SCSI adapter
Handle
Slot for
the first
FC420
bridge
Primary
electronics
module