TANDBERG REPLACE TAPE DRIVE IN STORAGELOADER VXA 433693-01 Manual - page 10
10 of 10
6.
Press
to display the cell selection screen:
7.
Press
or
to scroll through the occupied cell locations until the one you want appears.
8.
Press
to start the load operation. When the specified cartridge cell is in position at the
tape drive, the cartridge is loaded into the drive. A series of status messages appears during
the operation, followed by the Command menu when the operation is complete.
To unload a cartridge from the tape drive:
1.
From the Command menu, press
to see the menu selections.
2.
Press
or
until the following screen appears:
3.
Press
to display the cell selection screen:
4.
Press
or
to scroll through the available cell locations until the one you want appears.
5.
Press
to start the unload operation. When the tape drive ejects the cartridge, the
autoloader places the cartridge in the specified cell. A series of status messages appears
during the operation, followed by the Command menu when the operation is complete.
6.
If desired, press
to return to the Home screen.
L o a d
D r i v e
F r o m
C e l l
#
n
U n l o a d
D r i v e
U n l o a d
D r i v e
I n t o
C e l l
#
n