TANDBERG REPLACE TAPE DRIVE IN STORAGELOADER VXA 433693-01 Manual - page 7
of
10
7 of 10
Remove the faceplate as follows:
a.
Loosen the two M2.0 screws using a #1 Phillips screwdriver. Remove the screws and set
them aside for later use (see
Figure 11
).
b.
Rotate the faceplate in the direction of the blue arrow as shown in
Figure 12
.
c.
With the faceplate rotated upward, disengage the upper tabs from the top of the tape
drive chassis and remove the faceplate as shown in
Figure 13
.
Figure 11 Removing the VXA-320 (VXA-3) faceplate’s screws
Figure 12 Rotating the VXA-320 (VXA-3) faceplate up from the tape drive chassis
Figure 13 Lifting the VXA-320 (VXA-3) faceplate off the tape drive chassis.
Remove
screws
Rotate
Top tab (x2)