TANDBERG RX8310 User Manual - page 17
RX8310/RX8315/RX8330 Distribution Receiver
17
5
Quick Start Guide - Using the Front Panel Control
5.1
Making Signal Connections to the Unit
!
If you have an incoming satellite RF feed, connect this to the rear panel
connector marked RF Input
!
If you have an incoming ASI (Fiber) feed, connect this to the connector
marked ASI Input
!
Decoded PAL or NTSC video is output on connectors CVBS 1 and CVBS 2.
These outputs are identical in operation.
!
Decoded analogue or digital audio is output on connectors AUDIO OUT 1
and AUDIO OUT 2. Adaptor cables are used to provide the connector type
required for the installation.
!
The incoming feed is routed through the unit and output on connectors
ASI OUT 1 and ASI OUT 2
!
For models with option RX83XX/HWO/IP/OUT fitted, the incoming feed is
also routed through the unit and output on connectors IP OUT 1 and
IP OUT 2
!
If the unit is to be controlled by Web browser or PC based control system
then the control PC should be connected to connector CONTROL 1 or
CONTROL 2
!
If the unit is to be used to decrypt (non-Director) encrypted feeds then a
Conditional Access Module and card should be inserted in the slot labelled
Conditional Access Interface in the rear panel
5.2
Configuring the Inputs
5.2.1 ASI
Input
To configure the unit for ASI (Fiber) input.
!
Select ASIinput from a submenu off menu 2
5.2.2
Satellite (DVB-S or DVB-S2) Input
Ensure that the incoming feed is connected to connector 1.
To configure the unit for Satellite input the following User Settings should be
modified. All of these settings may be found in submenus off front panel menu 2.