TANDBERG Scholar MXP Assembly, Setup & User Manual - page 13
11. Lift* and hook the DISPLAY to
the top HORIZONTAL “U”
CHANNEL to mount onto the
CART.
*
THIS REQUIRES THE SUPPORT
OF AT LEAST ANOTHER
PERSON TO LIFT AND MOUNT
THE HEAVY DISPLAY!
12. Use the 3/8”–16 x 2” BOLTS
(4) to secure the DISPLAY to
the FRAME.
13. Mount the J-HOOK with a
3/8”–16 x 1” BOLT, NUT, and
WASHER into any spare hole
located on the HORIZONTAL
“U” CHANNEL.
14. Attach ADHESIVE-BACKED
FOAM to the top-front of
SPEAKER BAR as shown and
trim any excess foam.
15. Attach SPEAKER BRACKETS-B
(2) to the SPEAKER BAR using
the EXISITING SCREWS (4).
16. Attach the SPEAKER CABLE to
the SPEAKER BAR.
17. Mount the SPEAKER BAR and
BRACKET-B to SPEAKER
BRACKET-A on the FRAME
using ¼”–20 NUTS and ¼”
WASHERS (4) with the existing
studs on BRACKET-A.
18. Adjust the SPEAKER BAR to
align with the DISPLAY’S front
and bottom and securely
tighten the screws.
Page 13 of 32
TANDBERG SCHOLAR ASSEMBLY, SETUP AND USER GUIDE | D50564.01