- DL manuals
- TANGRA
- Boiler
- HP 30
- Installation And Operation Manual
TANGRA HP 30 Installation And Operation Manual
Summary of HP 30
Page 1
Manufactured in accordance with standard: - en 303-5 rev. 04 - 2014-03-28 installation and operation manual for pellet boiler tangra hp 30
Page 2
User manual tangra hp30 - rev. 04 - 2014-03-28 2.
Page 3
User manual tangra hp30 - rev. 04 - 2014-03-28 3 content 1. Introduction ........................................................................................................... 6 2. Safety ..............................................................................................................
Page 4
User manual tangra hp30 - rev. 04 - 2014-03-28 4.
Page 5
User manual tangra hp30 - rev. 04 - 2014-03-28 5.
Page 6: 1. Introduction
User manual tangra hp30 - rev. 04 - 2014-03-28 6 before start any installation, commissioning or service works, please read very carefully this manual! 1. Introduction the pellet boilers, manufactured by tangra, are produced in accordance with all applicable bulgarian and eu requirements. Their inst...
Page 7: 2. Safety
User manual tangra hp30 - rev. 04 - 2014-03-28 7 2. Safety these pellet boilers are designed according to en 303-5. It is forbidden, people without the necessary qualification (especially children) to handle with the pellet boiler or parts of it. The pellet boiler cannot operate in explosive, aggres...
Page 8
User manual tangra hp30 - rev. 04 - 2014-03-28 8 • installation and maintenance should be carried out by trained and qualified specialists (specialized company). Every action should be certified with a protocol. • it is not allowed to use plug-type "schuko" or other type of connection to the electri...
Page 9: 3. Guarangtee Conditions
User manual tangra hp30 - rev. 04 - 2014-03-28 9 3. Guarangtee conditions the manufacturer guarantee correct and flawless work of the unit when the installation and operating instructions are followed and the unit is installed from a certified by the manufacture installers. The guarantee starts from...
Page 10
User manual tangra hp30 - rev. 04 - 2014-03-28 10 the boiler consists of two separate modules – boiler body and storage tank for pellets. 4.1 technical data paremeter measure value heating capacity kw 17÷30 efficiency % 94 water volume l 320 volume of the pellet storage tank kg 250 flue gas connecti...
Page 11
User manual tangra hp30 - rev. 04 - 2014-03-28 11 4.2 main parts of the boiler „tangra hp 30” fig.1 n name 1 connection to the chimney system 2 connections to the heating system 3 controller 4 auger for automatic supply of the burner with fuel 5 pellet storage tank 6 compressor 7 burner 8 burning ch...
Page 12
User manual tangra hp30 - rev. 04 - 2014-03-28 12 5. Transport and storage 5.1 transport the units, boiler and storage tank, are supplied separately, mounted on a transport pallet. Loading and uploading are done with motor or electro fork lift or hand lift truck. The transportation of the boiler sho...
Page 13: 6. Installation
User manual tangra hp30 - rev. 04 - 2014-03-28 13 6. Installation 6.1 requirements for the technical room the boiler should be installed in a special technical room, which floor and walls are made of non-combustion materials with good ventilation and enough quantity of fresh air for the combustion p...
Page 14
User manual tangra hp30 - rev. 04 - 2014-03-28 14 • high-temperature (until 90 o c) closed water heating system with open or closed expansion tank, with maximum working pressure 2bar. When the system is supplied with closed expansion tank, it should be with minimum volume 35 l and pressure safety va...
Page 15
User manual tangra hp30 - rev. 04 - 2014-03-28 15 6.4.1 leveling of pellet boiler tangra cl35 • remove the packing of the boiler and the bunker. • place the boiler in the technical room (take into account the dimensions shown in fig.2 (6.1). • level the boiler body using the two front leveling screw...
Page 16
User manual tangra hp30 - rev. 04 - 2014-03-28 16 the other one to the free connection on the receiver (pneumatic hose Ø6 supplying the cleaning system cylinder). • connect the pneumatic hose Ø10 (from compressor) to the bottom side of the receiver. Join the main connector for supply of the boiler a...
Page 17: 8. Commissioning
User manual tangra hp30 - rev. 04 - 2014-03-28 17 6.6 electrical power supply main wire for electrical power supply - 3 х 1,5m 2 ,double insulated. 7. Requirements to the pellets „cl 35” is designed to work with wood pellets, with diameter 6-8mm, length 5-30mm and moisture content – 5-9%. With his i...
Page 18
User manual tangra hp30 - rev. 04 - 2014-03-28 18 8.3 set the capacity of the boiler: the capacity of the boiler depends on the quality and the quantity of the fuel supplied in the burner, measured in kg/h. The controller allows 5 levels – 1 (minimum capacity), 2.3.4 and auto (maximum capacity with ...
Page 19
User manual tangra hp30 - rev. 04 - 2014-03-28 19 if the boiler shall work without modulation, set the same values for parameter 1 and auto. 8.4 set the temperature in the boiler • from menu temperature set the water temperature in the boiler. When the boiler reaches this temperature, it will turn a...
Page 20: 9. Maintenance
User manual tangra hp30 - rev. 04 - 2014-03-28 20 9. Maintenance 9.1 cleaning of the combustion chamber accumulation of ash depends mainly of the quality of the pellets and operation hours of the boiler. The boiler is supplied with tray and blades to collect the ashes. We recommend once a week to ch...
Page 21
User manual tangra hp30 - rev. 04 - 2014-03-28 21 11.1 overheating of the system if the boiler temperature exceed the maximum, proceed as follows. • turn off the main power supply of the boiler • keep all doors of the boiler closed • open all valves, switch on all pumps • leave the technical room an...
Page 22: 12.
User manual tangra hp30 - rev. 04 - 2014-03-28 22 12. Appendix 12.1 wiring diagram.
Page 23: 13.
User manual tangra hp30 - rev. 04 - 2014-03-28 23 13. User manual - controller 13.1 turning on/off the boiler to turn on/off the power supply, please use the button, placed on the right side of the controller. Emergency stop button should be used only in case of accident. This button is unipolar and...
Page 24
User manual tangra hp30 - rev. 04 - 2014-03-28 24 the display shows the set or current values for the currently selected menu option. With buttons you can navigate through the menu and control the operation of tangra controller. Refer to the table on next page for descriptions of the buttons. It is ...
Page 25
User manual tangra hp30 - rev. 04 - 2014-03-28 25 13.2 schemes of the main menu.
Page 26
User manual tangra hp30 - rev. 04 - 2014-03-28 26 13.3 description of the functions.
Page 27
User manual tangra hp30 - rev. 04 - 2014-03-28 27.
Page 28
User manual tangra hp30 - rev. 04 - 2014-03-28 28 13.4 service menu of the boiler po s s ib le e rr o rs : Е 0 0 1 -ke y b o a rd e rr o r; e0 0 4 – m o th e rb o a rd c o m m u n ic a ti o n e rr o r; e1 0 8 – s e c u ri ty s w it c h e rr o r; e1 1 0 – n t c 1 e rr o r – t e m p e ra tu re s e n s...
Page 29
User manual tangra hp30 - rev. 04 - 2014-03-28 29 13.5 parameters of the controller swv1.4hp30/2014 n º p a ra m e te r d e s c ri p ti o n m e a s u re l im it s o f a c c e p ta b le v a lu e s r e c o m m e n d e d v a lu e s 0 maximum wait time for successful firing in ignition phase. Minutes 1 ...
Page 30
User manual tangra hp30 - rev. 04 - 2014-03-28 30 79 minimum light level of the flame sensor, after that there is no flame. 0 ÷ 30 5 80 time delay before off detected - defines the time during which flame sensor detects value under param. 79 before the burner to be stopped and blow cleaning started....
Page 31
User manual tangra hp30 - rev. 04 - 2014-03-28 31.
Page 32
User manual tangra hp30 - rev. 04 - 2014-03-28 32.