Manufactured in accordance with standard: - en 303-5 rev. 04 - 2014-03-28 installation and operation manual for pellet boiler tangra hp 30
User manual tangra hp30 - rev. 04 - 2014-03-28 2.
User manual tangra hp30 - rev. 04 - 2014-03-28 3 content 1. Introduction ........................................................................................................... 6 2. Safety ..............................................................................................................
User manual tangra hp30 - rev. 04 - 2014-03-28 4.
User manual tangra hp30 - rev. 04 - 2014-03-28 5.
User manual tangra hp30 - rev. 04 - 2014-03-28 6 before start any installation, commissioning or service works, please read very carefully this manual! 1. Introduction the pellet boilers, manufactured by tangra, are produced in accordance with all applicable bulgarian and eu requirements. Their inst...
User manual tangra hp30 - rev. 04 - 2014-03-28 7 2. Safety these pellet boilers are designed according to en 303-5. It is forbidden, people without the necessary qualification (especially children) to handle with the pellet boiler or parts of it. The pellet boiler cannot operate in explosive, aggres...
User manual tangra hp30 - rev. 04 - 2014-03-28 8 • installation and maintenance should be carried out by trained and qualified specialists (specialized company). Every action should be certified with a protocol. • it is not allowed to use plug-type "schuko" or other type of connection to the electri...
User manual tangra hp30 - rev. 04 - 2014-03-28 9 3. Guarangtee conditions the manufacturer guarantee correct and flawless work of the unit when the installation and operating instructions are followed and the unit is installed from a certified by the manufacture installers. The guarantee starts from...
User manual tangra hp30 - rev. 04 - 2014-03-28 10 the boiler consists of two separate modules – boiler body and storage tank for pellets. 4.1 technical data paremeter measure value heating capacity kw 17÷30 efficiency % 94 water volume l 320 volume of the pellet storage tank kg 250 flue gas connecti...
User manual tangra hp30 - rev. 04 - 2014-03-28 11 4.2 main parts of the boiler „tangra hp 30” fig.1 n name 1 connection to the chimney system 2 connections to the heating system 3 controller 4 auger for automatic supply of the burner with fuel 5 pellet storage tank 6 compressor 7 burner 8 burning ch...
User manual tangra hp30 - rev. 04 - 2014-03-28 12 5. Transport and storage 5.1 transport the units, boiler and storage tank, are supplied separately, mounted on a transport pallet. Loading and uploading are done with motor or electro fork lift or hand lift truck. The transportation of the boiler sho...
User manual tangra hp30 - rev. 04 - 2014-03-28 13 6. Installation 6.1 requirements for the technical room the boiler should be installed in a special technical room, which floor and walls are made of non-combustion materials with good ventilation and enough quantity of fresh air for the combustion p...
User manual tangra hp30 - rev. 04 - 2014-03-28 14 • high-temperature (until 90 o c) closed water heating system with open or closed expansion tank, with maximum working pressure 2bar. When the system is supplied with closed expansion tank, it should be with minimum volume 35 l and pressure safety va...
User manual tangra hp30 - rev. 04 - 2014-03-28 15 6.4.1 leveling of pellet boiler tangra cl35 • remove the packing of the boiler and the bunker. • place the boiler in the technical room (take into account the dimensions shown in fig.2 (6.1). • level the boiler body using the two front leveling screw...
User manual tangra hp30 - rev. 04 - 2014-03-28 16 the other one to the free connection on the receiver (pneumatic hose Ø6 supplying the cleaning system cylinder). • connect the pneumatic hose Ø10 (from compressor) to the bottom side of the receiver. Join the main connector for supply of the boiler a...
User manual tangra hp30 - rev. 04 - 2014-03-28 17 6.6 electrical power supply main wire for electrical power supply - 3 х 1,5m 2 ,double insulated. 7. Requirements to the pellets „cl 35” is designed to work with wood pellets, with diameter 6-8mm, length 5-30mm and moisture content – 5-9%. With his i...
User manual tangra hp30 - rev. 04 - 2014-03-28 18 8.3 set the capacity of the boiler: the capacity of the boiler depends on the quality and the quantity of the fuel supplied in the burner, measured in kg/h. The controller allows 5 levels – 1 (minimum capacity), 2.3.4 and auto (maximum capacity with ...
User manual tangra hp30 - rev. 04 - 2014-03-28 19 if the boiler shall work without modulation, set the same values for parameter 1 and auto. 8.4 set the temperature in the boiler • from menu temperature set the water temperature in the boiler. When the boiler reaches this temperature, it will turn a...
User manual tangra hp30 - rev. 04 - 2014-03-28 20 9. Maintenance 9.1 cleaning of the combustion chamber accumulation of ash depends mainly of the quality of the pellets and operation hours of the boiler. The boiler is supplied with tray and blades to collect the ashes. We recommend once a week to ch...
User manual tangra hp30 - rev. 04 - 2014-03-28 21 11.1 overheating of the system if the boiler temperature exceed the maximum, proceed as follows. • turn off the main power supply of the boiler • keep all doors of the boiler closed • open all valves, switch on all pumps • leave the technical room an...
User manual tangra hp30 - rev. 04 - 2014-03-28 22 12. Appendix 12.1 wiring diagram.
User manual tangra hp30 - rev. 04 - 2014-03-28 23 13. User manual - controller 13.1 turning on/off the boiler to turn on/off the power supply, please use the button, placed on the right side of the controller. Emergency stop button should be used only in case of accident. This button is unipolar and...
User manual tangra hp30 - rev. 04 - 2014-03-28 24 the display shows the set or current values for the currently selected menu option. With buttons you can navigate through the menu and control the operation of tangra controller. Refer to the table on next page for descriptions of the buttons. It is ...
User manual tangra hp30 - rev. 04 - 2014-03-28 25 13.2 schemes of the main menu.
User manual tangra hp30 - rev. 04 - 2014-03-28 26 13.3 description of the functions.
User manual tangra hp30 - rev. 04 - 2014-03-28 27.
User manual tangra hp30 - rev. 04 - 2014-03-28 28 13.4 service menu of the boiler po s s ib le e rr o rs : Е 0 0 1 -ke y b o a rd e rr o r; e0 0 4 – m o th e rb o a rd c o m m u n ic a ti o n e rr o r; e1 0 8 – s e c u ri ty s w it c h e rr o r; e1 1 0 – n t c 1 e rr o r – t e m p e ra tu re s e n s...
User manual tangra hp30 - rev. 04 - 2014-03-28 29 13.5 parameters of the controller swv1.4hp30/2014 n º p a ra m e te r d e s c ri p ti o n m e a s u re l im it s o f a c c e p ta b le v a lu e s r e c o m m e n d e d v a lu e s 0 maximum wait time for successful firing in ignition phase. Minutes 1 ...
User manual tangra hp30 - rev. 04 - 2014-03-28 30 79 minimum light level of the flame sensor, after that there is no flame. 0 ÷ 30 5 80 time delay before off detected - defines the time during which flame sensor detects value under param. 79 before the burner to be stopped and blow cleaning started....
User manual tangra hp30 - rev. 04 - 2014-03-28 31.
User manual tangra hp30 - rev. 04 - 2014-03-28 32.