Tanita AM-160 Instruction Manual - page 13
Sending Measurement Data to Your iPhone
When instructed to by the app, press and hold the
“ ” button
of
the Activity Monitor for two seconds or more.
“ ” is displayed after this, indicating that a connection can be made
within the next two minutes. (“ ” flashes during communication.)
The measurement data is sent to the iPhone and “ ” turns off.
REQUEST
・Measured values are recorded to the memory once every hour on the hour. To ensure that accurate measure-
ment data is sent, we recommend that you do not send data within five minutes before or after the hour.
→ This may cause data loss if the clock of the Activity Monitor is not accurate.
・Try to send measurement data each day
→ The Activity Monitor can store 15 days of data (including the current day), but from the 16th day, the
oldest data is overwritten with the new data.
・Measurement data cannot be sent to multiple iPhones.
→ Data that has already been sent cannot be resent.
Collecting Your Measurement Data
12
TOP
“ ” Button
How to Use
If "Re-connection" is displayed in the app, tap it to operate
your device.
NOTE :
To cancel communication after “ ” is displayed, press and
hold the “ ” button for two seconds or more. To avoid data
loss, communication cannot be canceled while data is being
sent (while “ ” is flashing).
If the connection fails, follow the steps above again.
Refer to each app for instructions on how to use the apps.
Select "Input Data"
→ "Steps" → "Input from device".
NOTE :
NOTE :