Tanita AM-160 Instruction Manual - Connecting to An Iphone
There are two ways of connecting to another iPhone.
“ ” and “ ” are displayed, indicating that a connection can be
made within the next two minutes. (“ ” flashes during communica-
tion.)
Connecting to an iPhone
Select "Input Data", then select "Steps".
8
TOP
After Changing the Battery
Connecting to Another iPhone
When instructed to by the app, press and hold the
“ ” button
of
the Activity Monitor for two seconds or more.
The display switches to the clock display when the connection is
complete.Tap "completed" in the app to save the data.
→ Tap "Completed" in the app to save the data.
・Connect by the same method as “Connecting to an iPhone for the First Time” (see p.7).
・Press and hold the “ ” button for five seconds or more in the Measurement Results screen (see p.13).
When “ ” is displayed, perform “Register a Device” in the app.
NOTE
・If the connection fails, follow the steps on p.7 or p.8 again.
・To cancel communication after “ ” is displayed, press and hold the “ ” button for two seconds or more.
To avoid data loss, communication cannot be canceled while data is being sent (while “ ” is flashing).
・When a new iPhone is connected, data that has already been sent to the previous iPhone is not sent to the
new iPhone.
・To connect to the previous iPhone again after connecting to another iPhone, perform “Register an Activity
Monitor” again from the app.
・The communication range of the AM-160 is approximately 5m. The range varies according to environmental
factors such as interference from other communication devices or obstructions.
・Refer to each app for instructions on how to use the apps.
“ ” Button
Befor
e Use