Tanita BF-684W Instruction Manual - Programming The Guest Mode
5
EN
Guest mode allows you to programe the unit for a one-time use without resetting a Personal
data number.
Press ▲ button to activate the unit. Then follow the steps: Set Age, Select Female or Male,
and Specify Height.
Note:
Ifyoustepontotheplatformbefore“0.0”appearsthedisplaywillshow“Error”and
you will not obtain a reading.
PROGRAMMING THE GUEST MODE
Select Weight-Only Key
PresstheWeight-onlykey.After2or3seconds,“0.0”willappearinthedisplayandtheunit
willbeep.When“0.0”appearsinthedisplay,stepontotheplatform.Thebodyweightvalue
willappear.Ifyouremainontheplatform,thedisplaywillflashforabout30seconds,and
then the power will automatically turn off.
Ifyoustepofftheplatform,theweightwillcontinuetoshowforabout5seconds,then“0.0”
will appear and the unit will shut off automatically.
TAKING WEIGHT MEASUREMENT ONLY
If the following problems occur ...then...
•Awrongweightformatappearsfollowedbykg,lb,orst-lb.
Refer to Switching the Weight Mode on p.3.
•“Lo”appearsonthedisplay,orallthedataappearsandimmediatelydisappears.
Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the
accuracy of your measurements. Change all the batteries at the same time with new AA-size batteries.
Note:Yoursettingswillnotbeerasedfromthememorywhenyouremovethebatteries.
•“Error”appearswhilemeasuring.
Please stand on the platform keeping movement to a minimum.
The unit cannot accurately measure your weight if it detects movement.
TheBodyFatPercentageismorethan75%,readingscannotbeobtainedfromtheunit.
•TheBodyFatPercentagereadingdoesnotappearor“-----”appearsaftertheweightismeasured.
Your personal data has not been programed. Follow the steps on p.3.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the
measuring platform.
•“OL”appearswhilemeasuring.
Reading cannot be obtained if the weight capacity is exceeded.