Tansun ALG 513 UK Reference Manual - page 2
2
Caution
When using Tansun electrical heaters, basic precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons,
including the following:
Read all instructions before using this heater.
•
Before using this appliance:
- Check that the voltage indicated on the type plate corresponds to the
mains supply voltage.
- Ensure that the heater has been securely fastened in its final mounting
position.
•
Do not locate the heater immediately below a socket outlet.
•
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be made by
children without supervision.
•
Children of less than 3 years should be kept away unless continually
supervised.
•
Children aged from 3 years and less than 8 years shall only switch on/
off the appliance provided that it has been placed or installed in its
intended normal operating position and they have been given
supervision or instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate and clean the appliance or
perform user maintenance.
•
CAUTION—Some parts of the product can become very hot and
cause burns. Particular attention has been given where children
and vulnerable people are present.
•
Remove the plug from the mains socket (or disconnect pole switch)
during installation, cleaning and/or replacing the element and always
ensure that the element is cool.
7
Fig. 10
10. Pull the lamp wires through the two access holes so it is ready to be unclipped and removed from the heater (Fig. 10).
9. Turn the heater body over and slide the side reflectors out at each end and then slide the guard out of the heater by pushing it
towards one of the ends where the end caps are removed (Fig. 8). Note: the reflectors sit on top of the guard legs for refitting.
Fig. 9
Fig. 8
Fig. 7a
8. From inside the heater body, gently pull the lamp wires through the sealing gasket so the lamp wires exit the terminal box and are
free as shown below in Fig. 8.
7. Remove the connector block retaining bridge by removing the screw and lifting out. This will allow the connector block to be lifted
out of its locating lugs to allow for better access when connecting the new lamp terminals. For now though leave it in its locating lugs
and unscrew the connector block screws as highlighted (Fig. 7a) and remove the white lamp wires so they are free (Fig. 7b).
Fig. 7b
LONGER WIRE
LONGER WIRE
RETAINING BRIDGE