Tansun Quartzheat RIV ELITE 060 Reference Manual - page 4
Installation Instructions
Always allow the heater to cool before attempting to reposition/move. Never attempt to move the heater while it is switched on!
Observe the minimum safe distance between the heater body and inflammable surfaces and objects when mounting.
Please refer to the specification table for the recommended positioning of the heater with regards to minimum distances. Do not
install the heater in a corner!
Keep out of the reach of children.
1. For transporting the Riviera Elite, the heater assembly is fitted to the base plate. It is recommended that the terminal box cover is
removed and one of the side pieces to gain access to the cable gland for later on in the installation. The M8 x 20 button head socket
screws and spring washers should be removed and retained while the cable tie should be left around the tubes until installation is
complete. Take the heater assembly off the base plate and store safely
4
MAINS
CABLE
CONCRETE
NB. Ensure the base is sitting level so the heater doesn’t lean when assembled.
2. Having made provision for cabling use, consider one of the following options for fixing the base to a suitable floor:
Option 1: Preset 1/2” or 12mm bolts in concrete and fasten Option 2: Fix the base into concrete or other similar flooring
the base with nuts and washers
SIDE PIECE
TERMINAL
BOX COVER
M8 x 20 BUTTON
HEAD SOCKET
SCREWS & SPRING
WASHERS
3 OFF
5
3. Slide a body pole (with joining pieces fitted) onto the three upright pieces on the base plate by matching the flat faces on the tube
with the flat faces of the upright piece, feeding the cable through. Secure in place with 3 X M8 x 20 button head socket screws placing a
M8 spring washer behind the head of the screw on all faces.
M8 SPRING WASHER
3 OFF
M8 x 20 BUTTON HEAD
SOCKET SCREW
3 OFF
4. Slide a body pole (with joining pieces fitted) onto
the three joining pieces of the previously mounted
body pole by matching the flat faces on the tube with
the flat faces of the joining pieces, feeding the cable
through. Secure in place with 3 X M8 x 20 button head
socket screws placing a M8 spring washer behind the
head of the screw on each face